Votos - 2, Puntuación media: 3.5
(
)
)
|
Resumen del manual
Top Panel Removed Trim Panels will be either Louvered Panels or Radiant Panels. Radiant Panels Louvered Panels Figure 1 -Remove Top Panel NOTE: DIAGRAMS & ILLUSTRATIONS ARE NOT TO SCALE. Bustles Figure 2 - Remove Bustles Lift Bustles Up And Off Only Some Models Have Bustles Bustles Figure 2 - Remove Bustles Lift Bustles Up And Off Only Some Models Have Bustles 2. Ensure the glass door assembly on the fireplace is properly aligned as follows: a. Open or remove lower compartment door (refer to Homeowner’s Manual provided with appliance). Note: Units with Modesty Panels - Remove the modesty panel as follows: Lift the modesty panel by the tab on the panel’s right end, pull the right end of the panel away from cabinet and then pull the panel diagonally out of the corner post slots on the left side of the unit. Remove the modesty panel carefully, so that none of the wires become loose or disconnected. b. Open the latch(es) at the bottom of the glass door assembly as shown in Figure 3 (refer to Homeowners Manual). c. Adjust glass door so that it is evenly spaced and aligned to the fi replace chassis on both sides. See Figure 3. d. Fasten the latch(es). Ensure that the latch(es) are engaged with the door’s vee-fl ange and fully closed. See Figure 3. Figure 3 -GLASS DOOR ADJUSTMENT Top Flange on Glass Door Bottom Vee-fl ange Glass Door Glass Door Latch Glass Door Firebox Floor Some models will have a modesty panel in the control compartment (in front of the valve). The appearance will vary from the example shown below. Modesty Panel Install Top of Door fi rst per Instruction #3 Doorframe Printed in U.S.A. © LENNOX HEARTH PRODUCTS 2005 P/N 750,199M REV. A 04/2006 Lennox Hearth Products reserves the right to make changes at any time, without notice, in design, materials, specifications, prices and the discontinuance of colors, styles and products. Consult your local distributor for fi replace code information. NOTE: DIAGRAMS & ILLUSTRATIONS ARE NOT TO SCALE. 1110 West Taft Avenue • Orange, CA 92865 Figure 5 - COMPLETED INSTALLATION Swing the bottom of the doorframe inward, then push into place Figure 4 - INSTALL DOORFRAME 3. Remove the arched screen doorframe from packaging, then install it as follows: a. Locate slots on each side of fi replace. b. Position the top of the doorframe above the top of the glass door assembly (centered and approximately 1” above glass door assembly). See Figure 4. Note: The bottom of the doorframe should be held slightly away as shown in Figure 4. Swing the bottom of the doorframe inward aligning the sides of the doorframe between the glass door and fireplace chassis and tabs on doorframe aligning into slots on fireplace. Swing the bottom of the doorframe in, then push down to ensure engagement. 4. Ensure that the latch(es) below the door are engaged with the door’s veefl ange and fully closed before operating the fi replace (see Figure 3). 5. (Units with Modesty Panels) Reinstall modesty panel, ensuring all wires are securely ...
Otros modelos de este manual:Puertas y ventanas - MPB-35 (227.78 kb)
Puertas y ventanas - MPB35ST (227.78 kb)
Puertas y ventanas - SSBV-35 (227.78 kb)
Puertas y ventanas - SSBV-40 (227.78 kb)