Votos - 4, Puntuación media: 4.3
(
)
)
|
Resumen del manual
Lennox's Symphony series Bi-Fold doors come standard with a decorator satin black finish and may be purchased in a polished brass finish designated by the -B suffix to the model/size number. Do not alter or modify these door assemblies or a fireplace malfunction or a fire hazard may result. These glass door assemblies have been tested and listed by Warnock Hersey Inc. PLEASE RETAIN THIS MANUAL FOR FUTURE REFERENCE. GENERAL INFORMATION This door assembly consists of a right and left bi-fold glass panel assembly factory mounted within an outer frame. Door handles are attached in place. There are no additional parts that are required to install the Symphony Series door, all required hardware is provided. Fireplaces listed on the front page of this document, have been designed to accept the Symphony Series doors with minimum effort. TOOLS REQUIRED Medium Phillips Screwdriver Hammer Electric Drill ...." Diameter Drill Bit Note: In most cases the door frame will not install completely flush with the appliance front face.The frame will usually protrude from the opening approximately an 1/8 of an inch. Model LBR and LBC Fireplaces Note:The Center Wedge Clip located inside thetrack in the center of the door frame indicates the bottom of the frame. It is important that the frame be installed with the correct side up to insure smooth operation of the doors. Step 1. Position the door support bracket along the lower front face of the appliance ash lip, oriented as shown (see Figure 1) (DO NOT affix the door support bracket to the outer front face of the appliance). Using the two (2) self tapping screws provided, secure the door support bracket to the front of the ash lip. Step 2. Position the frame in the fireplace opening on top of the door support bracket, centering left and right. Mark the fireplace at each hole in the side panels. Note:The frame is provided with two sets of holes allowing for near "Flush Face" installation and "Protruding" installations that may be particularly useful in certain finish applications. In most cases the door frame will not install completely flush with the appliance front face. The frame will usually protrude from the opening approximately an 1/8 of an inch. NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE Screw Support Bracket Door Screw *Note: This is an air inlet. DO NOT cover this space with any materials. * Detail Screw Support Bracket Door Screw *Note: This is an air inlet. DO NOT cover this space with any materials. * Detail Step 3. Remove the frame from the fireplace and drill a pilot hole 5/64" diameter at each of the four marks. Re-position the frame into the fireplace centering left and right. Insert the screws through the side panel holes and screw them into the pilot holes just drilled. Model Estate 48 Fireplaces Note:The Center Wedge Clip located inside the track in the center of the door frame indicates the bottom of the frame. It is important that the frame be installed with the correct side up to insure smooth op...
Otros modelos de este manual:Puertas y ventanas - 43LSBF (57.33 kb)
Puertas y ventanas - 43LSBF-B (57.33 kb)
Puertas y ventanas - 48LSBF (57.33 kb)
Puertas y ventanas - 48LSBF-B (57.33 kb)