Votos - 5, Puntuación media: 3.8
(
)
)
|
Resumen del manual
Output (free voltage contact), 3A@ 125Vac or 30Vdc ♦ Case Material: ABS (UL94V0) ♦ Operating Temperature:-20~+70°C ♦ Ambient Humidity:0~95% relative humidity non-condensing ♦ Visual Signals: ■ Green: Power on ■ Red: Relay activated ■ Yellow: Program Mode ' Lock-out ♦ Factory Master Code: 1234 ♦ Invalid PIN Lockout: System will shut down 60 seconds while 6 times of incorrectly password attempted. ♦ Relay Activation Time: (*20) ■ Pulse mode : 1~99 seconds (01~99) ■ Latching mode (00) ♦ EPROM: Non-volatile memory, System will retain all programs and codes after a total loss of power. ♦ User PINs: (*01~*10) It is possible to program 10 different user PIN codes. Copyright Gianni Industries, Inc. All Rights Reserved. P-MU-DG10-4C Ver. A Publish:2004.09.07 Page: 1/ 2 GEM GIANNI INDUSTRIES!, INC. III. Program Instruction: ♦ Enter Program Mode: 1. Enter the master code twice (Factory master is r 1234 j ) ^•2 beeps and the Yellow LED will light up. ^ you are now in the "programming mode". 2. Note: After 60 seconds if you have not entered any codes or data, the system will automatically exit from the programming mode. After 6 wrong attempts at the master code the lockout facility will operate. ♦ Exiting from the program mode: 1. Press r#j to exit from the programming mode. 2. Note: After 60 seconds if you have not entered any codes or data, the system will automatically exit from the programming mode. After 6 wrong attempts at the master code the lockout facility will operate. ♦ To Enter a User Code: Enter the Programming mode 1. Enter the slot position code r*01~*10j ^???? (user code 4 digit) ^ (beep) ^enrolled^ Press # to exit from the programming mode, or program other operating. 2. Note: The codes"0000","1234" or master code are not be used for PIN code. ♦ To Program Relocking Timer (relay): Enter the Programming mode A. Press r*20 j Followed by the number of seconds the relay should open^ r05 j =5 seconds (01 ~99 = seconds) ^ (beep) ^enrolled ^ Press r#j to exit from the programming mode, or program other operating. B. Enter r00 j Sets the relay to latching mode. (Correct code entered opens the relay, and the relay stays open until the correct code is entered again). ♦ To Delete a User Code : Enter the Programming mode^ Press the slot position code of your choice to delete (example "06") ^Press r*06j ^ r0000j ^ (beep) ^delete^Press r#j to exit from the programming mode, or programming other operating. ♦ To Change the Master codes: Enter the Programming mode, Enter r* 00 j Followed by the new 5 digit master code^ (beep) ^enrolled^Enter r#j to exit from the programming mode, or program other operating. IV. Wiring diagram: Note: The varistor or diode must be connected across the lock terminal (electromagnet... ) operated by the device. The vartistor controls the overload produced by the strike coil (EMP). Copyright Gianni Industries, Inc. All Rights Reserved. P-MU-DG10-4C Ver. A Publish:2004.09.07 Page: 2/ 2...
Otros modelos de este manual:Puertas y ventanas - DG-11 (208.05 kb)
Puertas y ventanas - DG-12 (208.05 kb)
Puertas y ventanas - DG-10 (208.05 kb)