Votos - 3, Puntuación media: 4.3
(
)
)
|
Resumen del manual
TURN OFF POWER AT SERVICE ENTRANCE BEFORE INSTALLING, WIRING, OR SERVICING THIS PRODUCT. 1. Hold chime mechanism against wall and mark four (4) mounting holes. 2. Drill 3/16” holes where marked and tap in wall anchors from parts bag. 3. Bring wiring through access hole(s) in chime mechanism backplate. 4. Loosely attach chime mechanism to wall with screws from parts bag. 5. C306 only. Slide brackets under screw heads. 6. Tighten screws securely. C306 only C306 only DO NOT OIL CHIME PLUNGERS. Oil will cause them to stick during operation. If plungers fail to operate freely due to accumulation of dust, cooking grease, etc., clean with a non-flammable cleaning solvent which will evaporate, leaving a dry surface. INSTALLATION (continued) 6. Connect wires to appropriate terminals. RECOMMENDED NEW CONSTRUCTION WIRING F S R123FrontSideRearGround120VoltAC16VACTransformerNine volt batteries not used Lighted or Unlighted Buttons NOT USED - OPTIONAL 2 or 3 chimes can be connected to a single transformer. 2 chimes require transformer Model C909 or C907. REPLACING EXISTING 2-NOTE CHIME F S R123LightedorUnlightedButtonsFrontSideRearGround120VoltAC16VACTransformerRequiresTwo9VoltBatteriesNOTUSED3 chimes require transformer Model C907. 9V9V 7. Install two (2) alkaline 9-volt batteries, if appropriate for your application. Turn on power at service entrance. Make sure pushbuttons operate chime properly. (Adjust switch on circuit board for 4 or 8 chime tones at front door. Side and rear doors will have 1 chime tone each.) 8. Hook cover over chime mechanism. 2 The three (3) chime bars must be held freely, within the decorative tubes in order to achieve and sustain the proper chime tone. When the chime bars are properly assembled to the mechanism, it should be possible to move each bar up and down slightly without moving the isolators. In the event that the chime bars become dislodged during shipping, please follow the instructions below to properly re-set them in the tubes. WARRANTY ONE YEAR LIMITED WARRANTY We warrant to the original consumer purchaser of our products that such products will be free from defects in materials or workmanship for a period of one year from date of original purchase. THERE ARE NO OTHER WARRANTIES, EXPRESSED OR IMPLIED, INCLUDING, BUT NOT LIMITED TO, IMPLIED WARRANTIES OR MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE. During this one-year period, we will, at our option, repair or replace, without charge, any product or part which is found to be defective under normal use and service. THIS WARRANTY DOES NOT EXTEND TO FLUORESCENT LAMP STARTERS AND TUBES. This warranty does not cover (a) normal maintenance and service or (b) any products or parts which have been subject to misuse, negligence, accident, improper maintenance or repair (other than by us), faulty installation or installation contrary to recommended installation instructions. The duration of any implied warranty is limited to the one-year period as specified for the express...
Otros modelos de este manual:Puertas y ventanas - C306 (116.99 kb)
Puertas y ventanas - C305RW (116.99 kb)