Votos - 4, Puntuación media: 4.3
(
)
)
|
Resumen del manual
Determine pivot location using dimensions on reverse side. The pivots are handed and must match hand of door. To determine hand of door and proper pivot position, see diagrams above. Install top and bottom pivot sets before installing intermediate pivot. 2. Locate, drill, and tap 1/4-20 mounting holes for metal door. Locate and drill pilot holes for #14 wood screws for wood door. Then hang door. 3. Open door about 90°. Install pivot leafs with 1/4-20 x 3/4” FHMS or #14 FHWS screws provided. 4. The door weight should be balanced between bottom and intermediate pivots. To adjust intermediate pivot (refer to diagram above): A. Loosen set screw in jamb leaf with 3/32” Allen wrench. B. Insert 5/32” Allen wrench through jamb leaf pivot and into underside of bearing spindle. C. Turn clockwise until door weight is balanced evenly with bottom pivot. D. Tighten 3/32” set screw securely. A CAUTION Improper pivot set installation can lead to personal injury or property damage. Follow all instructions carefully. For questions contact Technical Support at 1-888-371-7331. I*"7 Ingersoll Rand 13103 Rev. 4 © 2006 Ingersoll-Rand Company Limited Security Technologies NOTE It is very important for installer to verify that intermediate pivot point lines up with center line of top and bottom pivot points before final installation. Both door and frame pivot leafs located from face of door. Intermediate pivot should be evenly spaced between top and bottom pivots. Heel edge of door must be beveled 1/8” in 2”. Frame Leaf Door Leaf Right hand installation shown; left hand opposite 13103-00 13103 Rev. 4 13103-00...
Otros modelos de este manual:Puertas y ventanas - Offset Top Pivot 7222 (22.67 kb)