Votos - 4, Puntuación media: 3.8
(
)
)
|
Resumen del manual
Use sex bolts on metal doors not reinforced. Recommended mounting is stop on door. Remove and discard safety net screw except lor inverted. top of door applications. 1: Mount back plate with centerline 3H" from latch edge of door and top of plate 5" from bottom of door, as indicated in illustrations at right and below. Locate screw holes by using back plate as template. Use #8 x 1" flat head sheet metal screws for wood doors, or #8-32 x W flat head machine screws for reinforced metal doors. 2: Place stop assembly on back plate and push it down on tapered legs, with locking set screw fully retracted. Then raise stop assembly approx. %" (to provide adjustment) and lock in position with locking set screw. 3; Hold strike under stop assembly with roller fully engaged in slot. Move door so as to contact wall with strike. Locate strike screw holes, using strike as template. 4: Mount strike with four #12 x V/i" oval head screws. 5: Adjust stop assembly on back plate to clearance between housing and strike as shown in illustration, using a drill as spacer. Secure with locking set screw. 6: Holding power is adjusted by turning adjusting screw counterclockwise to increase tension and clockwise to decrease tension. Further adjustment can be made by moving stop assembly up or down on back plate. WALL TOP OF BACK PUTE BOTTOM OF DOOR WALL TOP OF DOOR TOP OF BACK PUTE TOP OF DOOR (INVERTED) WALL TOP OF BACK PUTE No. 495 ‘REQUIRED ONLY IN INVERTED, TOP OF DOOR APPLICATION. WALL STRIKE APPLICATIO top of door 1: Mount back plate with centerline 31-3” from latqh edge of door and top of plate l!-i" from top of door, as indicated in illustration at left. Locate screw holes by using back plate as template. Use #8 x 1" flat head sheet metal screws for wood doors, or #8-32 x y," flat head machine screws for reinforced metal doors. 2: Follow instructions 2 through 6 as outlined above Jor No. 495 bottom of door application. top of door (inverted) 1: Mount backplate (inverted, with rubber bumper a: top) with centerline 3!j" from latch edge of door and top of plate (in verted, see illustration) 5" from top of door. Locate sçrew holes, etc. as in instruction 1 above. 2: Place stop assembly on back plate and push it up on tapered legs, with locking set screw fully retracted. Then lower stop assembly approx. M“ (to provide adjustment) and look in posi tion with locking set screw. Secure safety set screw by turning until head is flush with housing. Screw then extends beyond dovetail of backplate and prevents stop assembly fjom falling when final adjustment is being made. 3: Hold strike in inverted position over stop assembly with roller fully engaged in slot. Follow instructions 3, 4, 5 & 6 at top of page. USE OF ARCUATE SLOT CURVED SLOT IN _j STRIKE PERMITS d USE OF WALL STRIKE 5 WHEN DOOR AND WALL ARE NOT PARALLEL. § ■ ARC OF SLOT ROLLER PASSES THRU CENTER OF ASC. PM...