Votos - 5, Puntuación media: 3.6
(
)
)
|
Resumen del manual
To reduce the risk of death or injury by electric shock: 1. Always “unplug it” immediately after using. 2. Do not use while bathing. 3. Do not place or store appliance where it can fall or be pulled into a tub or sink. 4. Do not place in, or drop into, water or other liquid. 5. If an appliance falls into water, “unplug it” immediately. Do not reach into the water. WARNING – To reduce the risk of burns, electrocution, fire, or to persons: 1. This appliance should never when plugged twist, or wrap line 2. This appliance should on, or near children or individuals disabilities. 3. Use this appliance only for its intended use as described in this manual. Do not use attachments not recommended by the manufacturer. Do not use an extension cord to operate dryer. 4. Never operate this appliance if it has a damaged cord or plug, if it is not working properly, if it has been dropped, damaged, or dropped into water. Return the appliance to a Conair Service Center for examination and repair. 5. Keep the cord away from heated surfaces. Do not wrap the cord around the appliance. 6. Never block the air openings of the appliance or place it on a soft surface, such as a bed or couch, where the air openings may be blocked. Keep the air openings free of lint, hair, and the like. 7. Never use while sleeping. 8. Never drop or insert any object into any opening or hose. 9. Do not use outdoors or operate where aerosol (spray) products are being used or where oxygen is being administered. 10. Do not use an extension cord with this appliance. 11. Do not direct hot air toward eyes or other heat-sensitive areas. 12. Attachments may be hot during use. Allow them to cool before handling. 13. Do not place appliance on any surface while it is operating. 14. While using the appliance, away from the air inlets. 15. Do not use with voltage For a dual voltage 16. Be sure dual voltage voltage position before operating. Before plugging in, read the information about dual voltage contained in the instruction section of this manual. 17. This appliance was set at the factory to operate at 125 volts. Refer to Additional Information section of this manual for conversion to 250 volt operation. SAVE THESE INSTRUCTIONS OPERATING INSTRUCTIONS This appliance is intended for household use only. Use on Alternating Current (50/60 hertz) only. Standard Dryers are designed to operate at 110 to 125 volts A.C. For special dual voltage dryers, see Additional Information. This appliance has a polarized plug (one blade is wider than the other). As a safety feature, this plug will fit in a polarized outlet only one way. If the plug does not fit fully in the outlet, reverse the plug. If it still does not fit, contact a qualified electrician. Do not attempt to this safety feature. IMPORTANT 1875 WATT OPERATING GUIDE Use of this dryer on the same circuit or fuse with other electrical products or appliances may trip a 15 amp circuit breaker or blow a 15 amp fuse. NEVER replace the fuse with one rated higher than the capacity of the circuit. Doing so could result in an electrical fire. WHAT TO DO IF HAIR DRYER ACCIDENTALLY FALLS IN WATER PLEASE NOTE: When the electrical elements of the hair dryer come in contact with water, the Protection Plus ® Plug is designed to shut down immediately. 1. Be sure to unplug the hair dryer. 2. Remove from water. Once the appliance is removed from water, it should be returned to a Conair service center. REMEMBER: Do not use the hair dryer after it has fallen in the water until it has been serviced. CHECK ALCI SAFETY FEATURE EVERY TIME YOU USE APPLIANCE. This appliance is equipped with an Appliance Leakage Circuit Interrupter (ALCI), a safety feature that renders it inoperable under abnormal conditions, such as immersion water. To make sure the ALCI is functioning properly, perform the following test. The purpose of this test is to allow the water sensing system 1. Plug in the appliance on plug (See appropriate 2. The appliance an audible click 3. To reset ALCI with a reset button, unit should be unplugged. Then push reset button in, and reinsert plug into outlet. Reset Test Reset Test 4. If ALCI is not functioning properly, return appliance to nearest service center. 5. It is important that if immersion occurs, this unit be brought to a service center. Do not try to reset. 6. Be sure to repeat test every time you use the unit to confirm ALCI is operational. Should the appliance go off and the reset button pop up during use, this could indicate a malfunction in the unit. Remove plug from outlet and allow the appliance to cool. Reinsert plug into outlet. The appliance should then function normally. If not, return to an authorized Conair Service Center for evaluation and repair. SUPER STYLING GUIDE Your best looks begin with a good haircut that’s well maintained. Always treat hair Conair ® and Jheri Redding ® superior quality shampoos, conditioners, and DRYING BASICS 1. Shampoo and condition ® or Jheri Redding ® products of your choice. tho...