Votos - 2, Puntuación media: 4.5
(
)
)
|
Otros manuales para este modelo:
Resumen del manual
Lock lever 3 Close the battery cover. To remove the battery pack Turn off the camera and slide the lock lever in the direction of the arrow. Be careful not to drop the battery pack. Lock lever To check the remaining battery level To check the remaining battery level Battery level “Battery exhausted” High Low You cannot shoot any more pictures. What is an “InfoLITHIUM” battery pack? An “InfoLITHIUM” battery pack is a lithium-ion battery pack that has functions for exchanging information related to operating conditions with your camera. Using the “InfoLITHIUM” battery pack, the remaining battery time in percent figures is displayed according to the operating conditions of your camera. Notes • The displayed level may not be correct under certain circumstances. • Do not expose the battery pack to water. The battery pack is not water-resistant. • Do not leave the battery pack in extremely hot places, such as in a car or under direct sunlight. Available battery packs Use only an NP-FM500H battery pack. Note that the NP-FM55H, NPFM50 and NP-FM30 cannot be used. The number of images that can be recorded The approximate number of images that can be recorded is 880 when you use the camera with the battery pack at full capacity. Note that the actual numbers may be less than those indicated depending on the conditions of use, the attached lens, or the memory card. • The number is calculated with a battery pack at full capacity and in the following situation: – At an ambient temperature of 25°C (77°F). – [Quality] is set to [Fine]. – Focus mode is set to AF-A (Automatic AF). – Shooting once every 30 seconds. – The power turns on and off once every ten times. Preparing the camera 19 • • • The battery capacity decreases as the number of uses increases and also over time. • The number of images that can be recorded is decreased under the following conditions: – The surrounding temperature is low. – The camera has been turned on and off many times. – Focus mode is set to AF-C (Continuous AF). – When the camera continues to focus for a long time without shooting, including cases where you press and hold the shutter button halfway down. Effective use of the battery pack Battery performance decreases in low temperature surroundings. So, the time that the battery pack can be used is shorter in cold places. We recommend the following to ensure longer battery pack use: put the battery pack in a pocket close to your body to warm it up, and insert it in your camera immediately before you start shooting. Battery life • The battery life is limited. Battery capacity decreases little by little as you use it more and more, and as time passes. If the battery operating time seems shortened considerably, a probable cause is that the battery pack has reached the end of its life. Buy a new battery pack. • The battery life varies according to how it is stored and the operating conditions and environment in which each battery pack is used. How to store the battery pack If the battery pack is not to be used for a long time, fully charge it and then fully use it up once a year on your camera before storing the battery pack in a dry, cool place to prolong the battery life. Attaching a lens Attaching a lens 2 Mount the lens by aligning the orange index marks on the lens and camera. Orange index marks Preparing the camera 3 Turn the lens clockwise until it clicks into the locked position. • When attaching a lens, do not press the lens release button. • Be sure to put the lens on straight. Notes • The shutter is not released if the lens is not attached, except when the mode dial is set to M (page 53). • Using a DT lens is not guaranteed because the corners of the field are darkened and the camera does not meet the primary AE performance standard. To remove the lens 1 Press the lens release button all the way in and turn the lens counterclockwise until it stops. • When changing the lens, quickly change the lens away from dusty locations so as to keep dust from getting inside the camera. Lens release button 21 2 Replace the cap on the lens and attach the body cap to the camera. 2 Replace the cap on the lens and attach the body cap to the camera. Before you attach the cap, remove dust from the cap. Note on changing the lens The camera is equipped with an anti-dust function to prevent dust from landing on the image sensor. However, quickly change the lens away from dusty locations to keep dust or debris from getting inside the camera when attaching/removing a lens. If dust or debris lands on the image sensor Clean the image sensor using [Cleaning mode] in the Setup menu (page 34). Inserting a memory card Inserting a memory card 1 Open the memory card cover. 2 Insert a memory card (sold Terminal part separately) from the terminal part (the terminal side has a number of small holes). Set the face side with the label toward the LCD monitor. • For “Memory Stick Duo” media, insert it all the way in until it clicks. Terminal part 3 Close the memory card cover...
Otros modelos de este manual:Cámaras - DSLR-A850Q (3.01 mb)