Votos - 6, Puntuación media: 4.2
(
)
)
|
Otros manuales para este modelo:
Resumen del manual
• The icon for the selected flash mode is displayed at the top of the monitor. • When z is selected, the icon is only displayed for five seconds after the setting is applied. • The flash mode applied in Lmode is stored in the camera’s memory even after the camera is turned off. 26 Flash 4 44 Basic Photography and Playback: L(Auto) Mode Using the Flash j When Lighting is Poor Note the following when lighting is poor and the flash is off (B). • Place the camera on a flat, level surface or use a tripod (recommended). When using a tripod, turn the vibration reduction off (c21). •The W icon is displayed when the camera increases sensitivity from the normal sensitivity to minimize blur caused by slow shutter speeds. The picture taken when the W icon is displayed may be slightly mottled. Basic Photography and Playback: L (Auto) Mode • The camera may process pictures to reduce noise, which makes recording time increase. jNote on Using the Flash When using the flash at a wide-angle zoom position, bright reflections from dust particles in the air may appear as bright spots in the pictures. To reduce these reflections, set the flash to B(Off) in the monitor or zoom in on the subject. kThe Flash Lamp The flash lamp indicates flash status when the shutter-release button is pressed halfway. • On : Flash will fire when picture is taken. • Blinks : Flash charging. Wait a few seconds and try again. • Off : Flash will not fire when picture is taken. kRed-eye Reduction The COOLPIX L5 is equipped with an advanced red-eye reduction system. Pre-flashes are fired several times at low intensity before the main flash to reduce “red-eye”. If the camera detects “red-eye” after a picture is taken, Nikon’s own In-Camera Red-Eye Fix processes the image as it is recorded. Therefore, there is a slight delay before the shutter-release button operates normally to take another picture. Red-eye reduction may not always produce the desired results. In some rare cases, other portion of pictures may be affected. Should this occur, choose Flash lamp another flash mode and try again. 27 Taking Pictures with the Self-Timer The camera is equipped with a ten-second timer for self-portraits. When using the self-timer, mount the camera on a tripod (recommended) or rest it on a flat, and stable surface. 1 Press H(self-timer). • The self-timer menu is displayed. 2 Press the multi selector G or H to choose [On] and press d. •The 10Hicon is displayed. • The monitor will return to the normal display for the current mode if the setting is not applied by pressing dwithin five seconds. • For information on using the multi selector, see “Multi Selector” (c8). OFF ON OFF Self-timer 3 Frame the picture and press the shutter-release button halfway. • The focus and exposure are adjusted. 101010 44 4 Press the shutter-release button fully. • The self-timer starts. • The self-timer lamp will blink for about nine seconds. The lamp stops blinking one second before the photograph is taken and remains lit until the shutter is released. • A countdown of the time remaining until the shutter is released is displayed in the monitor. • To cancel the self-timer without taking a 101010 44 Basic Photography and Playback: L(Auto) Mode picture, press the shutter-release button again before the picture is taken. 28 Macro Close-up Mode Macro close-up mode is used for taking pictures of objects as close as 4 cm (1.6 in.). Note that the flash may be unable to light shots entire subject at distances of less than 50 cm (1 ft. 7.7 in.). If flash fires, play the picture back and check the results. 1 Press L (macro close-up mode). • The macro close-up mode is displayed. 2 Press the multi selector G or H to choose [On] and press d. •The Ficon is displayed. • The monitor will return to the normal display for the current mode if the setting is not applied by pressing d within five seconds. • For information on using the multi selector, see “Multi Selector” (c8). 3 Press v (k) or t (j) to frame the picture. • Minimum focus distance varies with zoom position. The camera can focus at a distance of 4 cm (1.6 in.) at the zoom position at which L turns green. Basic Photography and Playback: L (Auto) Mode ON OFF Macro close-up 4 Focus and shoot. • The macro close-up mode applied in L mode is stored in the camera’s memory even after the camera is turned off. k Macro Close-up Mode In macro close-up mode, the camera focuses continuously, even when the shutter-release button is not pressed halfway to lock focus. 29 Exposure Compensation Exposure compensation is used to alter exposure from the value suggested by the camera to make pictures brighter or darker. 1 Press I(exposure). 2 Press the multi selector Gor Hto adjust exposure. • When the picture is too dark: adjust the exposure compensation to “+” side. • When the picture is too bright: adjust the exposure compensation to “-” side. • The monitor will return to the normal display for Exp. +/the current mode if the setting is not applied by pressing dw...