Votos - 0, Puntuación media: 0
(
)
)
|
Otros manuales para este modelo:
Resumen del manual
x Charging time Full charge time Normal charge time Approx. 245 min. Approx. 185 min. GB Notes Notes The table above shows the time required to charge a fully depleted battery pack at a temperature of 25°C (77°F). Charging may take longer depending on conditions of use and circumstances. • Connect the battery charger to the nearest wall outlet (wall socket). • When charging is finished, disconnect the power cord (mains lead) from the wall outlet (wall socket), and remove the battery pack from the battery charger. • Be sure to use the battery pack or the battery charger of the genuine Sony brand. x Battery life and number of still images you can record/view Battery life (min.) No. of Images Recording Approx. 125 Approx. 250 Viewing Approx. 250 Approx. 5000 Note • The number of still images that can be recorded is based on the CIPA standard, and is for shooting under the following conditions. (CIPA: Camera & Imaging Products Association) – [LCD Brightness] is set to [Normal]. – Shooting once every 30 seconds. – The zoom is switched alternately between the W and T ends. – The flash strobes once every two times. – The power turns on and off once every ten times. – A fully charged battery pack (supplied) is used at an ambient temperature of 25°C (77°F). – Using Sony “Memory Stick PRO Duo” media (sold separately). zUsing the camera abroad You can use the camera and the battery charger (supplied) in any country or region where the power supply is within 100 V to 240 V AC, 50/60 Hz. Do not use an electronic transformer (travel converter). This may cause a malfunction. GB Inserting the battery pack/a memory card (sold separately) 1 Open the cover. 2 Insert a memory card (sold separately). With the notched corner facing as illustrated, insert the memory card until it clicks into place. GB Note the notched corner facing the correct direction. 3 Insert the battery pack. Align the battery pack with the guide inside the battery insertion slot. Then, pressing the battery eject lever with the edge of the battery pack in the direction of the arrow, insert the battery pack until the battery eject lever locks into place. Battery eject lever 4 Close the cover. Securely close the battery cover until you hear the slide lock on the cover catch in place and so that the yellow mark under the slide lock can no longer be seen. • If foreign matter such as sand gets inside the cover, the sealing gasket may be scratched and it may cause a malfunction (page 8). GB x x The following memory cards are compatible with this camera: “Memory Stick PRO Duo” media, “Memory Stick PRO-HG Duo” media, “Memory Stick Duo” media, SD memory card, SDHC memory card and SDXC memory card. However, all memory cards are not guaranteed to work with this camera. MultiMediaCard is not compatible. Images recorded on an SDXC memory card cannot be transferred or played back on computers or AV devices that are not exFAT-compatible, even when the camera is connected to the computer or AV device using a USB cable. Before connecting, make sure that the device is exFAT-compatible. If connected to a device that is not exFAT-compatible, a format drive request may appear. Do not format the drive, or all data will be lost. (exFAT is the file system used by SDXC memory cards.) • In this manual, the term “Memory Stick Duo” media is used to refer to “Memory Stick PRO Duo” media, “Memory Stick PRO-HG Duo” media and “Memory Stick Duo” media, and the term “SD card” is used to refer to SD memory card, SDHC memory card and SDXC memory card. • When recording movies, it is recommended that you use the following memory cards: – (Mark2) (“Memory Stick PRO Duo” (Mark2) media) – (“Memory Stick PRO-HG Duo” media) – SD memory card, SDHC memory card or SDXC memory card (Class 4 or faster) Note • This camera should be operated at between –10°C and +40°C, but according to the type of memory card, the operating temperature may vary. For details, see the operating instructions supplied with the memory card. For details on the number of images/time that can be recorded, see page 27. x To remove the memory card Make sure that the access lamp is not lit, Access lamp then push the memory card in once. Note GB • Never remove the memory card/the battery pack when the access lamp is lit. This 18 may cause damage to data or the memory card. x x Images are stored in the camera’s internal memory (approximately 45 MB). To copy images from the internal memory to a memory card, insert a memory card in the camera, then touch t (Settings) t (Memory Card Tool) t [Copy]. x To remove the battery pack Slide the battery eject lever. Be sure not to drop the battery pack. Battery eject lever GB x Notes on the multi-connector cover To open the multi-connector cover, first open the battery/memory card cover. Then, pull the notch on the left side of the multi-connector cover out with the fingernail. Close the multi-connector cover firmly, then the battery/memory card cover. Multi-connector cover x Checking the remaining...