Votos - 0, Puntuación media: 0
(
)
)
|
Otros manuales para este modelo:
Resumen del manual
Operating Instructions.” Refer to “. Operating Instructions” on the names of parts, depth-of-field table (in meters). Other information, such as notes on use, can be found in “. Operating Instructions” and “Precautions before using” on a separate sheet. . Attaching/detaching the lens To attach the lens 1 Remove the front and rear lens caps and the camera body cap. 2 Align the orange index on the lens barrel with the orange index on the camera (mounting index), then insert the lens into the camera mount and rotate it clockwise until it locks. ..Do not press the lens release button on the camera when mounting the lens. ..Do not mount the lens at an angle. To remove the lens While pressing and holding the lens release button on the camera, rotate the lens counterclockwise until it stops, then detach the lens. . Attaching the lens hood It is recommended that you use a lens hood to reduce flare and ensure maximum image quality. Loosen the locking screw on the lens hood and slip the lens hood over the front of the lens. Check that lens hood is attached properly, and then tighten the screw. ..When using a built-in camera flash, make sure to remove the lens hood to avoid blockage of the flash light. Attaching the lens front cap When storing, turn the lens hood back over the lens, and tighten the screw to secure the lens hood to the lens. Attach the lens to the lens front cap firmly, zip the fastener tape and tighten with the stopper. ..When attaching the lens front cap to the lens hood, align the holder of the lens hood on the hole of the lens front cap. . Attaching a tripod Attach the tripod to the lens, not to the camera. To change vertical/horizontal position Loosen the collar-locking knob on the tripod-mounting collar (1) and rotate the camera either direction. The camera can be quickly switched between vertical and horizontal positions while maintaining stability when using a tripod. ..Gray indexes (collar indexes) are located at 90° intervals on the tripod-mounting collar. Align a gray index on the tripod-mounting collar with the gray index (lens index) on the lens to adjust the camera position precisely (2). ..Tighten the collar-locking knob firmly after the camera position is set. 4-433-638-11(1) ©2012 Sony Corporation Interchangeable Lens SAL300F28G2 300mm F2.8 G SSM II . Operating Instructions A-mount Printed in Japan (1) (2) To detach the tripod-mounting collar The tripod-mounting collar can be detached. 1 Remove the lens from the camera. ..See “. Attaching/detaching the lens” for details. 2 Loosen the collar-locking knob (1). 3 Rotate the tripod-mounting collar to align the red index on the tripod-mounting collar (collar mounting index next to SET/RELEASE) with the orange index on the lens (lens mounting index) (3). 4 Move the tripod-mounting collar towards the lens mount and detach the tripod-mounting collar from the lens (4). (3) (4) . Attaching the strap Attach the strap so that the lens can...