|
Resumen del manual
Super Capacity Frontload Electric Dryer Dimensions and Installation Information (in inches) Electric Dryer Rating 240V 5600W, 24A, 60Hz 208V 4400W, 22A, 60Hz 271-5/841-1/231-1/83-3/4 Exhaust Options: 4-way via rear, right, left and bottom. Circuit Requirements: An individual, properly grounded branch circuit, protected by a 30-amp circuit breaker or a time-delay fuse, is required. Note: Dryer wall outlet must be located within 36” of service cord entry and accessible when dryer is mounted in position. Installation Information: For complete information, see installation instructions packed with your dryer. 5-1/2 For answers to your Monogram,® GE Profile™ or GE® appliance questions, visit our website at ge.com or call GE Answer Center® service, 800.626.2000. Listed by Underwriters Laboratories Specification Revised 1/08 360459 For answers to your Monogram,® GE Profile™ or GE® appliance questions, visit our website at ge.com or call GE Answer Center® service, 800.626.2000. Special Installation Requirements: Stacked Installation: • Brackets for stacking dryer over washer are not included with the washer. Order part no. WE25X10018. Alcove or Closet Installation: • If your dryer is approved for installation in an alcove or closet, it will be stated on a label on the dryer back. • The dryer MUST be exhausted to the outside. • Minimum clearances between dryer cabinet and adjacent walls or other surfaces are: 0" either side, 3" front and rear. • Minimum vertical space from floor to overhead cabinets, ceilings, etc. is 52". • Closet doors must be louvered or otherwise ventilated and must contain a minimum of 60 sq. in. of open area equally distributed. If this closet contains both a washer and a dryer, doors must contain a minimum of 120 sq. in. of open area equally distributed. • No other fuel-burning appliance shall be installed in the same closet with a gas dryer. Bathroom or Bedroom Installation: • The dryer MUST be exhausted to the outdoors. • The installation must conform with the local codes, or in the absence of local codes, with the National Fuel Gas Code, ANSI Z223. Minimum Clearance other than Alcove or Closet Installations: • Minimum clearances to combustible surfaces 0" both sides, 3" rear. For more information on venting kits and accessories, please call 1-800-GE-CARES. Stacked Dimensions (in inches) 80-1/8 27 13 28-3/4 Pedestal Dimensions (in inches) SBSD137HWW - white This optional 13" pedestal raises the door opening and height of the washer or dryer. Feet on 13" pedestal allow it to adjust to 13-3/8" height. Listed by Underwriters Laboratories Specification Revised 1/08 360459 DBVH520EJ GE® 7.0 Cu. Ft. Super Capacity Frontload Electric Dryer DBVH520EJ GE Dryer Vent GE® 7.0 Cu. Ft. Super Capacity Frontload Electric Dryer Dryer Exhausting Information – Metal Duct Only For complete information, see installation instructions packed with your dryer. Best Performance Ducting Materials: For best performance, this dryer should be vented with 4” d...
Otros modelos de este manual:freidoras - DBVH520EJ (382.92 kb)
freidoras - DBVH520EJ (382.92 kb)