Votos - 4, Puntuación media: 4.3 ( )

Fabricar: Bolens Tamaño del archivo: 114.36 kb Nombre del archivo: Idioma del manual:

Residual dirt and grass is easily removed immediately after mowing. 1. Remove grass deposits with a brush and a cloth. 2. Oil the red cutting mechanism lightly with thin oil (e.g. sprayed oil). 7. Troubleshooting DANGER! Cutting tool can cause injuries! V Wear suitable work gloves when rectifying faults. 10 Fault Possible Cause Rectification Abnormal Noises Screws / components loose v Tighten screws Foreign bodies on the blade. v Remove foreign bodies. Notch in the blade v Remove notches with grindstone. Blades are striking each other v Adjust cutting mechanism. too hard. Lawn is not cleanly cut Blade adjustment incorrect. v Adjust cutting mechanism. Blade blunt. v Regrind or replace blade. Grass too long (e.g. after a v Cut lawn shorter with a relatively long absence). sickle. GB Adjusting the cutting mechanism: 980A 9B0 The cutting gear of your lawn mower was optimally adjusted before leaving our company. If, after longer use, a clean cut of the grass is no longer possible or the blade roller contacts the lower blade, then the lower blade should be adjusted as follows: 1. Unhook upright and clean cylinder mower. 2. Check cylinder 9 and lower blade 0 for notches and remove these with a grindstone if necessary. 3. Unscrew internal hexagon screws A with an internal hexagon wrench (5 mm) anticlockwise until the cylinder 0 turns freely. 4. Push the feeler gauge supplied (thin strip of metal) 8 between one blade 9 on the cylinder and the lower blade 0. 5. Tighten left internal hexagon screw A with an internal hexagon wrench (5 mm) until the feeler gauge 8 is held gently. 6. Continue turning the cylinder until the blade 9, already adjusted on the left side, is exactly above the lower blade 0 on the right side. 7. Tighten the right internal hexagon screw A with an internal hexagon wrench (5 mm) until the feeler gauge 8 is held gently. 8. Rotate cylinder 9. If a banging noise is produced during this, open up the internal hexagon screw A slightly on the side affected. When the cylinder and the lower blade can hardly be heard touching each other, the cutting mechanism has been adjusted correctly. 9. Cutting test: Place a strip of paper B in such a way on the lower blade 0 that it points towards the spindle of the cylinder 9. 10. Turn cylinder 9 carefully. If the lower blade is set correctly 0 the paper will be cut off as if with scissors. 11. Repeat the cutting test on the other blades 9. 11 GB Regrinding/repairs: 8. Accessories A A On safety grounds, only original GARDENA spares may be used. Please contact GARDENA Service if it is necessary to replace the cutting tool, which will only become blunt after several years use if well-maintained. Repairs to the cylinder mower and the installation of the blades can be undertaken by suitable specia list workshops. Have the cylinder mower checked over in the autumn if possible so that it is ready for use immediately when the next lawn-mowing season starts. If you have any problem with your cylinder mower, plea...

Descargar ahora

Introduzca dos números de la imagen: