Votos - 1, Puntuación media: 5
(
)
)
|
Resumen del manual
Button Functions: On•Deal•Draw – Press this button to turn the game on, deal your first five (5) cards (5 points will automatically be bet). After you HOLD the cards you want to keep, press this button again to DRAW new cards. Hold (5) – Press these buttons according to which card you want to keep. Press these buttons again to release the HOLD on that card. Sound – Press this button to turn the sound on or off. High•Score – Press this button at any time to see the highest score achieved on this unit since the last time the computer was reset or the last time the batteries were installed or re-inserted. Reset – Press this button to reset the game. This will erase the high score achieved on this unit. H HHo ool lld dd High • Score Reset On • Deal • Draw Sound LIGHT -Slide the button to the left to turn the light on and right to turn off. Remember to turn off the light after playing to save battery. PROTECTIVE LID -Press side button to open lid. The lid can be removed by popping off hinge points. PLAYING THE GAME: Turn on the game by pressing the On•Deal•Draw button. Press the On•Deal•Draw button again to deal your first set of cards. Five (5) points are automatically bet. Select the cards you wish to hold by using the Hold buttons, which are located directly below each card. Royal Flush 5000Straight Flush 2504 of a Kind 125Full House 40Flush 25Straight 203 of a Kind 152 Pair 10Jacks or Better 5 Press the On•Deal•Draw to receive your next set of cards. If you have a winning hand, your points will increase by the amount listed on the pay table on the back of your game. NOTE: If your point total gets down to zero, 100 points is automatically added to your total. Maximum displayable score: 99,995. SLEEP MODE: Flip Top Poker will go to sleep after one minute of non-activity. To wake the game, press the On•Deal•Draw button. BATTERY INSTALLATION: This game is powered by two (2) AAA batteries. •Using a screwdriver, loosen the screw until the battery compartment door can be removed. •Insert two (2) AAA batteries (we recommend alkaline) as indicated inside the battery compartment. •Replace the battery compartment door and tighten the screw with a screwdriver. Do not over-tighten. ADULT SUPERVISION IS RECOMMENDED WHEN CHANGING BATTERIES. CAUTION: •As with all small batteries, the batteries used with this game should be kept away from small children who might still put things in their mouths. If a battery is swallowed, consult a physician immediately. •Be sure you insert the battery correctly and always follow the game and battery manufacturer’s instructions. •Do not dispose of batteries in fire. •Batteries might leak if improperly installed, or explode if recharged, disassembled or heated. MAINTENANCE: •Handle this game carefully. •Store this game away from dusty or dirty areas. •Keep this game away from moisture or extreme temperature. •Do not disassemble this game. If a problem occurs, press the Reset button or remove and replace the batteries to reset the computer, or try new batteries. If problems persist, consult your warranty information located at the end of this instruction manual. •Use only the recommended battery type. •Do not mix old and new batteries. •Do not mix alkaline, standard (carbonzinc) or rechargeable (nickel-cadmium) batteries. •Do not use rechargeable battery. •Do not attempt to recharge non-rechargeable battery. •Remove any exhausted battery from the game. •Do not short-circuit the supply terminals. •Insert battery with the correct polarity. Please retain this for future reference. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference and (2) this device must accept any interference received, including interference that may cause undesired operation. WARNING: Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: •Reorient or relocate the receiving antenna. •Increase the separation between the equipment and receiver. •Connect the equipment into an outlet on a circuit different from that to which the receiver is conne...