Votos - 3, Puntuación media: 4 ( )

Fabricar: Invacare Tamaño del archivo: 250.77 kb Nombre del archivo: Idioma del manual:

The correct anti-tippers must be ordered to maintain a 1. to 2-inch ground clearance. For more information regarding Invacare products, parts, and services, please visit Part No 1086188 1 Anti-tippers INSTALLATION WARNINGS (CONTINUED) Anti-tippers MUST be fully engaged. Ensure that the locking pin of the anti-tipper fully protrudes out of the hole on the wheelchair frame. Ensure both anti-tippers are adjusted to the same height. Anti-tippers MUST be used at all times. When outdoors on wet, soft ground or on gravel surfaces, anti-tippers may not provide the same level of protection against tipover. Extra caution must be observed when traversing such surfaces. Ensure the anti-tipper wheels are pointing towards the ground/floor BEFORE operating the wheelchair. After ANY adjustments, repair or service and BEFORE use, make sure that all attaching component parts are secure. Installing Anti-Tippers NOTE: For this procedure, refer to FIGURE 1. 1. Remove the plug button or end cap from end of lower frame tube. 2. Visually inspect the top and bottom of lower frame tube for locking hole(s). NOTE: Depending on your wheelchair frame style, one (1) of the following conditions will exist: •One locking hole located on top of the lower frame tube. •One locking hole located on the bottom of the lower frame tube. •Locking holes located on both the top and the bottom of the lower frame tube. 3. If there are no hole locations for the anti.tippers to lock into position, drill a 9/32.inch diameter hole through one wall at the bottom of the lower frame tube. This hole should be placed 15/16.inch from the back edge of the lower frame tube. 4. Place the anti.rattle over the end of the lower frame tube (if applicable). 5. Depress the release buttons and insert the anti.tippers into the wheelchair frame tubing with the anti.tipper wheels pointing toward the ground/floor. 6. Ensure that the release button of the anti.tipper fully protrudes out of the locking hole(s) in the lower wheelchair frame tubing. 7. Repeat STEPS 1.6 for the opposite anti.tipper. NOTE: A 1. to 2.inch clearance between the bottom of the anti.tipper wheels and the ground/floor MUST be maintained at all times. Anti-tippers 2 Part No 1086188 8. Measure the distance between the bottom of the anti.tipper wheels and the ground/floor. •Non.Adjustable HeightAnti.Tipper Assemblies: Ifthe distance between the bottom of the anti.tipper wheels and the ground/floor is not 1. to 2.inches, call Invacare Technical Support at the number listed on the back page. •Adjustable Height Anti.Tipper Assemblies: If the distance between the bottom of anti.tipper wheelsand theground/floorisnot1. to2.inches,adjustanti.tippers. Refer to Adjusting Anti.Tippers on page 3. Spring Button(s) (STEP 5) *Anti-Tipper(if provided) (STEP 4) Frame TubeLower Locking Hole (9/32-inch Diameter) *NOTE: Non.adjustable Anti-Rattle (STEPS 2,3) anti.tipper shown. 15/16-inch (STEP 3) Plug Button or End Cap (End cap not shown) (STEP 1) ...

Descargar ahora

Introduzca dos números de la imagen: