Votos - 3, Puntuación media: 4 ( )

Fabricar: Graco Inc. Tamaño del archivo: 284.6 kb Nombre del archivo: Idioma del manual:

. Do not exceed the maximum working pressure of the lowest rated component in your system. This equipment has a 120 psi (0.8 MPa, 8 bar) maximum working pressure and 120 psi (0.8 MPa, 8 bar) maximum incoming air pressure. . Solvent Compatibility: – Use fluids and solvents which are compatible with the equipment wetted parts. – Use only compatible solvents to clean all plastic parts. Many solvents can degrade plastic parts to the point where they could fail. Refer to the Technical Data section of all equipment manuals. Read the fluid and solvent manufacturer’s warnings. . Do not use hoses to pull equipment. . Do not lift pressurized equipment. . Comply with all applicable local, state, and national fire, electrical, and safety regulations. . Do not operate outside the minimum and maximum operating temperature of your surge suppressor unit. See Minimum and Maximum Operating Temperatures on page 7. . . WARNING TOXIC FLUID HAZARD Hazardous fluid or toxic fumes can cause serious injury or death if splashed in the eyes or on the skin, inhaled, or swallowed. . Know the specific hazards of the fluid you are using. . Store hazardous fluid in an approved container. Dispose of hazardous fluid according to all local, state and national guidelines. . Always wear protective eyewear, gloves, clothing and respirator as recommended by the fluid and solvent manufacturer. . Pipe and dispose of the exhaust air safely, away from people, animals, and food handling areas. If the diaphragm fails, the fluid is exhausted along with the air. . Never use an acetal pump to pump acids. Take precautions to avoid acid or acid fumes from contacting the pump housing exterior. Stainless steel parts will be damaged by exposure to acid spills and fumes. FIRE AND EXPLOSION HAZARD Improper grounding, poor ventilation, open flames or sparks can cause a hazardous condition and result in a fire or explosion and serious injury. . Charge the surge suppressor with compressed air or nitrogen only. Do not use oxygen. Such use could result in an explosion. . Never pump flammable fluids with polypropylene units. . Ground the equipment. Refer to Grounding on pages 4 and 5. . Never use a polypropylene pump or surge suppressor with non-conductive flammable fluids as specified by your local fire protection code. Refer to Grounding on pages 4 and 5 for additional information. Consult your fluid supplier to determine the conductivity or resistivity of your fluid. . If there is any static sparking or you feel an electric shock while using this equipment, stop pumping immediately. Do not use the equipment until you identify and correct the problem. . Provide fresh air ventilation to avoid the buildup of flammable fumes from solvents or the fluid being pumped. . Pipe and dispose of the exhaust air safely, away from all sources of ignition. . Keep the work area free of debris, including solvent, rags, and gasoline. . Electrically disconnect all equipment in the work area. . Extinguish all open flames or ...

Descargar ahora

Introduzca dos números de la imagen: