Votos - 0, Puntuación media: 0
(
)
)
|
Otros manuales para este modelo:
Resumen del manual
Please use reasonable precaution. 1. Place the case upright on a flat, stable surface. The power supply fan should be at the back, facing you. 1 2. Remove the screws from the right side panel. 3. There are two latches on the side panel. Slide the latches towards the front of the case and swing open the panel. 4. Inside the case you should see the power supply, some wiring with marked connectors (USB, PWR etc.), and installed I/O panel and a power cord. Installing the Motherboard This manual does not cover CPU, RAM, or expansion card installation. Please consult the motherboard manual for specific mounting instructions and troubleshooting. 1. Lay the case down, with the open side facing up. The drive cages and power supply should be visible. 2. Make sure you have the appropriate I/O panel for the motherboard. If the panel provided is not suitable for the motherboard, please contact the motherboard manufacturer for the correct I/O panel. 3. Line up the motherboard with the standoff holes, and remember which holes are lined up. Not all motherboards will match with all the provided holes; this is normal, and won’t affect functionally. 4. Remove the motherboard by lifting it up. 5. Screw the brass standoffs into the threaded holes that line up with the motherboard. Do not overtighten the standoffs. Some standoffs may be pre-installed for your convenience. 6. Place the motherboard on the brass standoffs. 7. Screw in the motherboard to the standoffs with the provided Philips-head screws. 8. The motherboard is now installed. Connecting the Power and LED The power supply conforms to the ATX12V Version 2.2 standard. If the motherboard has a 20-pin power receptacle, detach the 4-pin attachment on the 24-pin power connector, see pictures 1 and 2. Before you connect the power supply to any devices, please consult the appropriate user manuals for the motherboard and other peripherals. 1. Connect the 24-pin Main Power Connector and the 4-pin or 8-pin 12V connector to the motherboard as needed. If the motherboard uses a 20-pin Picture 1 Picture 2 connector; detach the 4-pin attachment on the 24-pin power connector (see pictures 1 and 2). Note: the detachable 4-pin section cannot be used in place of a 4-pin +12V connector. For 24-pin For 20-pin 2. Connect the Reset switch (labeled RESET SW) to motherboards motherboards the motherboard at the RST connector. Polarity (positive and negative) does not matter for switches. 3. Power Switch (labeled POWER SW) connects to the PWR connector on the motherboard. 4. Power LED (labeled POWER LED) connector is located behind the Reset connector. For LEDs, colored wires are positive (+). White or black wires are negative (–). If the LED does not light up when the system is powered on, try reversing the connection. For more info on connecting LEDs to your motherboard, see your motherboard manual. 5. Hard Drive LED (labeled H.D.D. LED) connects to the IDE connector. ...
Otros modelos de este manual:Fuente de alimentación y fuente de alimentación - NSK 6580B (86.03 kb)