Votos - 0, Puntuación media: 5
(
)
)
|
Resumen del manual
Note the following: • Before installing a new screen protector, remove any screen protector that is already installed. A notch in the corner of the screen protector allows you to slide your fingernail or a firm, pliable implement (such as a credit card) under the screen protector for removal. Do not use a metal implement; it could scratch the screen. • To ensure good adhesion, clean the display screen with a soft cotton cloth dampened with denatured alcohol before installing the screen protector. When the alcohol dries, it may leave streaks on the screen. If streaking occurs, buff the screen gently with a clean, dry cloth to remove the streaks. 1. The step is for installation on the harsh environment case (HEC) only: Remove edge from screen protector, as shown in Figure 1. Figure 1. Removing Edge for HEC Installation 2. Peel the protective film from the adhesive side of the screen protector, as shown in Figure 2. FUJITSU 3. Install the screen protector on the pen tablet or harsh environment case. Apply the adhesive side to the screen with the notch in the lower left corner, as shown in Figure 3. 4. Apply pressure along the edges of the screen protector with your finger. (Avoid lifting the screen protector from the screen after it is installed. The adhesive requires 48 hours to cure properly.) Figure 3. Installing the Screen Protector 5. Remove the protective film from the top of the screen protector, as shown in Figure 4. Figure 4. Removing the Protective Film 6. Wipe the exposed surface of the screen protector with a clean dry cloth to remove any adhesive left behind by the protective film. 9/99 PenCentra 130 is a trademark of Fujitsu Personal Systems, Inc. © 1999 Fujitsu Personal Systems, Inc. 58-0674-00B...