Votos - 3, Puntuación media: 4.7
(
)
)
|
Resumen del manual
15). A second person should gently remove the glass (fig. 17). To clean the inner pane of the oven door on both sides operate as follows: – Open the oven door. – Remove the seal G by unhooking the no. 3 fixing hooks (fig. 16). – Gently pull out the inner pane of glass (Fig. 17.). Forcible removal of the door glass may lead to damage of the door hinges. – Clean the glass with an appropriate cleaner. Dry thoroughly, and place on a soft surface. – Now you can also clean the inside of the outer glass. G Fig. 16 Fig. 17 Fig. 15 20 20 Replacing the inner pane of glass To replace the inner pane of the door operate as follows: – Check that the four rubber pads are in place (D in Fig. 18). – Whilst one person holds the door still, a second person should insert the inner pane in the left E and right F side guides (fig. 19) and gently let it slide up to the retainers H (fig. 20). Forcible replacement of the door glass may lead to damage of the door hinges. – Reassemble the seal G in the correct way (fig. 21) by hooking the no. 3 fixing hooks in the proper holes. DFig. 18 D EFF E HFig. 19 Fig. 20 H G Fig. 21 The oven door has a sealed gasket in the top part. It is normal the opened gap between the top edge of the inner glass and the sealed gasket. This allows the cooling air circulation. Fig. 22 21 21 ADVICE FOR THE INSTALLER Important Appliance installation and maintenance must only be carried out by QUALIFIED TECHNICIANS and in compliance with the local safety standards. • Failure to observe this rule will invalidate the warranty. • Always disconnect the appliance from the electrical supply before carrying out any maintenance operations or repairs. • The walls surrounding the oven must be made of heat-resistant material. • Taking care NOT to lift the oven by the door handle. WARNING When correctly installed, your product meets all safety requirements laid down for this type of product category. However special care should be taken around the rear or the underneath of the appliance as these areas are not designed orintended to be touched and may contain sharp or rough edges, that may cause injury. 22 22 Important The oven can be fitted in standard units, width and depth 60 cm. Installation requires a compartment as illustrated in figures 23 and 24. On the lover side, the oven must lay on supports standing the oven weight. Note: please consider the side opening of the door (either right of left hinged, dependent on model) when installing the oven. Once installed you should be able to open the oven door to screw the fixing screws (not supplied - Fig. 27). 56050585Fig. 23 560 550 min 591 594 594 540 20 536 min Fig. 24 23 To ensure internal ventilation, aeration channels must be provided as illustrated in the figures 25 and 26. 30 mm 600 50 mm 50 550 Fig. 25 Fig. 26 24 24 Fixing the Oven Introduce the oven into the furniture opening and fix it with screws (not supplied) as figure 27. It is essential that the oven rests on a surface which will support its weight, as the screw fixing is only complementary. Note It is essential that when installing your oven adequate air circulation is allowed for within the installation. See figures 25 - 26. Inadequate air circulation may greatly impair the performance of your oven and may effect adjacent cabinets due to an increase in temperature. Caution Do not lift this oven by the door handle Adjust the hinges of furniture doors adjacent to the oven to allow a 4-5 mm gap between the furniture door and the oven frame. Fig. 27 25 25 IMPORTANT: – To avoid damage to the lower trim please note the following instructions. – The lower trim is designed to allow for good air circulation and the correct opening of the oven door. – To ensure the trim is not damaged due to the appliance being placed on the floor, the appliance should be suitably supported as in below illustrations. – After installation the appliance door should be slowly opened to ensure no damage has occurred. – No responsibility for lower trim damage will be accepted if these instructions have not been followed. OVEN DOOR LOW ER TRIM AIR FLOWAir Flow Oven Door Lower Trim Fig. 28 26 26 Incorrect installation may be dangerous and the manufacturer can not be held responsible. Warning! This appliance must be earthed The manufacturer declines all responsibility for any THIS APPLIANCE MUST BE CONNECTED TO THE MAINS SUPPLY BY A COMPETENT PERSON, USING FIXED WIRING VIA A DOUBLE POLE SWITCHED FUSE SPUR OUTLET AND PROTECTED BY A 13A We recommend that the appliance is connected by a qualified electrician, who is a member of the The wires in the mains lead of this appliance are coloured in accordance with the following code: FUSEONFUSE SPUR OUTLET USE A 13 AMP FUSE DOUBLE POLE SWITCHED Fig. 29 Mains Electricity Connection problem caused by failure to observe this rule. FUSE. N.I.C.E.I.C. and who will comply with the I.E.E. and local regulations. Green & Yellow = Earth, Blue = Neutral, Brown = Live. As the colours of the wires in the mains le...
Otros modelos de este manual:Hornos Eléctricos - SC220L (1.68 mb)