Votos - 0, Puntuación media: 0
(
)
)
|
Resumen del manual
Press the release button (1) and open the cover of the cartridge compartment (2). 10 EnglisH 2121 3 4 Slide the cartridge with the pump into the shaver. It only fits properly if the white side of the pump is pointing upwards. Close the cover (you will hear a click). Press the yellow pump button a few times until the NIVEA FOR MEN shaving gel/lotion appears.The shaver is now ready for use. Replacing cartridges Do not throw the pump away when you replace an empty cartridge.You will need it for the other cartridges. 1 2 3 Press the release button (1) and open the cover of the cartridge compartment (2). Remove the empty cartridge and pull out the pump. Push the pump into a new cartridge until itlocks into position with a click. 4 Slide the cartridge with the pump into the shaver. It only fits properly if the white side ofthe pump is pointing upwards. Close the cover. Storing cartridgesYou can conveniently store the other cartridges by attaching them to the wall holder supplied. The holder has suction caps which allow you to attach it to the wall easily. In this way you always have the cartridges close at hand, which is very convenient, especially when you shave in the shower. , EnglisH 11 Using the appliance shaving Switching on the shaver The wall holder is only suitable for storing cartridges. Never hang or place the shaver on the wall holder. If you do, the shaver may fall! 1 Press the on/off button once to switch on the shaver. After the batter y capacity has been shown briefly, the yellow teardrop-shaped shaving gel light ± flashes 3 times to indicate that shaving gel/lotion can be applied. If the shaver does not go on when you press the on/ off button, the travel lock may have been activated. Deactivate the travel lock (see chapter ‘Travel lock’). 2 3 4 Press the yellow pump button to apply NIVEA FOR MEN shaving gel/lotion to your skin. Move the shaving heads over your skin, making both straight and circular movements. While shaving, press the pump button frequently to apply more NIVEA FOR MEN shaving gel/lotion so that the shaver keeps gliding smoothly over your face. Do not press the shaver too hard against your skin while shaving. If you prefer, you can wet your face before shaving. For the best shaving results, shaving gel/lotion , , , should be pumped up frequently. The shaver will not perform optimally when used without shaving gel/lotion. Your skin may need 2 or 3 weeks to get accustomed to the Philips shaving system. 12 EnglisH Switching off the shaver 1 Press the on/off button once to switch off the shaver. The cleaning reminder a (green tap symbol with flashing water jet) lights up for 6 seconds to indicate that the shaver should be cleaned. After this, the remaining batter y capacity is shown for 5 seconds. 2 Clean the shaver (see chapter ‘Cleaning and maintenance’). Rinse the shaver after each shave. Remove the car tridge if you are not going to use the appliance for more than one week. 3 4 If necessary, check the remaining battery capacity by pressing the on/off button. One or more battery lights will go on for seconds to indicate the remaining battery capacity. Put the protection cap on the shaver every time you have used it, to prevent damage. If necessary, activate the travel lock (see chapter ‘Travel lock’). Trimming For grooming sideburns and moustache. attaching the trimmer 1 Switch off the shaver. Clean the shaver before you attach the trimmer (see chapter ‘Cleaning and maintenance’). 2 EnglisH 13 2121 Press the release button (1) and pull theshaving unit off the shaver (2). 3 Tilt the trimmer slightly backwards. 4 Fit the trimmer onto the shaver (you will hear a click).The trimmer is now ready for use. Activate the trimmer by pressing the on/off button once. Removing the trimmer 1 2 3 Switch off the shaver. Remove the trimmer by pressing the release button again and pulling the trimmer off theshaver. Put the shaving unit back onto the shaver. Travel lock If you are going to store the shaver for a longer period or if you are going to travel, it is possible to lock the shaver.The travel lock prevents the shaver from being switched on by accident. 14 EnglisH Cleaning and maintenance activating the travel lock 1 Press the on/off button for 3 seconds.The motor is switched off. 2 The travel lock indication a, a yellow key symbol, flashes 3-4 times and then burns continuously for 4 seconds.The travel lock has now been activated. The yellow key symbol goes out. deactivating the travel lock 1 Press the on/off button for at least 3 seconds. The yellow key symbol lights up. 2 The yellow key symbol flashes 3-4 times.Then the motor starts running to indicate that the shaver has been unlocked.The shaver is now ready for use again. The yellow key symbol goes out. Note:The shaver unlocks automatically when you place the shaver in the plugged-in charging stand. Checking if the appliance is locked 1 Press the on/off button briefly (less than 3 seconds). 2 The yellow key symbol lights up for 3 seconds t...
Otros modelos de este manual:Eléctrico - HQ7780/16 (2.62 mb)
Eléctrico - HQ7780/33 (2.62 mb)