Votos - 1, Puntuación media: 4
(
)
)
|
Resumen del manual
60% maintains the relative humidity around 60% for personal comfort. 70% maintains the relative humidity around 70% in the room. 80% maintains the relative humidity around 80% in most cases the compressor will be OFF. To set the desired relative humidity level press the or button repeatedly. Setting the fan speed. Push the SPEED BUTTON to change the fan speed, the chosen speed will be indicated on the LCD, for the high speed and for the low speed. Setting the Timer The timer switches the unit on and off automatically. Make sure that the clock is set to the real time so that the timer can operate the unit accurately. When the unit runs (is ON) Push the TIMER BUTTON, the 2 left digits will blink; adjust the desired hour when the unit will switch OFF by repeatedly pressing the or button. Push the TIMER BUTTON again, the 2 right buttons will blink; adjust the minutes by repeatedly pressing the or button. (The minutes can be set in steps of 5 minutes, 5, 10, 15 up to 55 ). If an ON setting is desired after the OFF, repeat the above procedure. To activate the timer settings push the SET BUTTON one more time. 9 GB GB When the unit is OFF. Follow the same procedure as above for the ON and if required continue to the OFF setting. Cancelling the timer In order to cancel the timer setting(s), push the TIMER BUTTON. UV light (optional) Normally the blue UV light will be ON whenever the unit is connected to the electricity. In order to turn the blue UV light off, push the UV BUTTON, the UV light will go OFF and the UV icon on the LCD will disappear. Pushing the UV BUTTON again will light the UV light. When the front door opens, a micro switch cuts off the electricity. Heater The heating function may run together with the compressor or alone. The heater will run only when the room temperature is below 25 °C. To operate the heating function, press the TEMP&HEAT BUTTON. Room relative humidity Normally the 2 digits indicate the relative humidity % in the room. If the relative humidity is lower then 35% the 2 digit icon indicate . If the relative humidity is higher then 95% the 2 digit icon indicate . Room temperature Push the TEMP&HEAT BUTTON for 2 seconds and the LCD will indicate the room temperature. SCENT EMITTER The unit is supplied with a scent emitter to fragrance the air. • take out the scent capsule from its bag • take the scent emitter cover off by turning it and pulling it out • fix the capsule into its airy seat in the back of the unit • return the cover to its place. 10 MAINTENANCE GB Always unplug the unit from the mains before carrying out any maintenance or cleaning the unit. Cleaning the body Use only a soft cloth to wipe the unit clean. Do not use volatile chemicals, petrol, detergents, chemically treated cloths or other harmful cleansing solutions. These could all possibly damage the cabinet. Cleaning the washable air filter This dehumidifier is equipped with a washable filter. This will capture most airborne pollutants like dust, smoke, animal dander, mould spores and pollen to create a less irritating living environment. It is advisable to check the filter on a regular basis (at least monthly and after storage) and clean as necessary: • Extract the filter holder • Use a vacuum cleaner or tap the filter lightly. If the filter is particularly dirty, use luke-warm water with a small amount of medium strength detergent and rinse thoroughly under the cold water tap. Make sure the filter is completely dry before replacing. Do not expose the filter to sunlight or other sources of direct heat as this may cause the filter and frame to warp. Cleaning and replacing the carbon filter. The carbon filter can be cleaned with a vacuum cleaner, never rinse it with water. We suggest to replace the carbon filter every 6 months. Optional filters 3M HAF filter PCO – Photo Catalytic Oxidation (optional) TiO2 filter is included in the multi air filter. Bacteria carried by the air are being killed by the TiO2 filter. STORAGE If the dehumidifier is not used for long periods of time, follow these steps: • disconnect the unit and wrap the power cable. • if used, empty the water container, remove the scent emitter . • clean the unit and filter, pack it in its original packaging or cover to protect against dust. • store the unit in an upright position in a cool, dry place away from access by children. 11 12 GB When the water tank is full, the unit will switch off and beep 10 times, the blue led on the control panel will become red and the icon on the LCD will come on. At this time please empty the water tank as follows: • open the front door • pull the water tank partly out by the recession at the bottom of the tank • raise the handle, carry the tank to the drain point and empty the water by the small triangle opening in the cover of the tank • once emptied, gently push the tank back into its place checking that the icon goes out and the red led turns back to be blue. EMPTYING THE WATER TANK To clean the water tank follow these ste...
Otros modelos de este manual:Eléctrico - PLDA (637.28 kb)
Eléctrico - plda 19EH (637.28 kb)