|
Resumen del manual
• Do not exceed rated supply voltage (120, 240V depending on model). Excess voltage may cause controller damage or failure. • NOTE: The heater may be installed in any position when used with continuous gas flow. However, with interrupted or pulsed airflow, and the heater is vertically mounted (pointing downward), the inlet air sensors may be activated and turn heater power off. This occurs due to the natural rising of heat from the barrel to the control box. This results in delayed start-up (2 minutes or more), and mounting in this manner is not recommended. Installation • Securely mount the heater to prevent movement. • Connect the filtered air source to the heater. • Remove the wiring box cover (two screws). • Connect the WHITE wire to one POWER lead. • Connect the BLACK wire to the other POWER lead. • Connect the GREEN wire to GROUND. • Tighten the cord clamp and replace the wiring box cover. Start-up • Turn on air supply and adjust to desired flow/pressure. • Set the red knob to one (1). • Switch on power to the heater. • Adjust the red temperature control knob upward for desired temperature. Performance Curves The following curve shows maximum temperature vs. flow rate for the G-TEMP heaters. Temperature measurements were made with an exposed-junction type “K” thermocouple located 1” from the heater exit. Use of other temperature measuring devices, or different thermocouple positions will generate different results. 131 Portsmouth Ave. Exeter, NH 03833 USA Tel: 800-258-8290 Fax: 603-772-1072 OPERATING INSTRUCTIONS OSRAM 8/12/00 SYLVANIA Process Heat Warranty OSRAM SYLVANIA warrants that all products to be delivered hereunder will be free from defects in material and workmanship at the time of delivery. OSRAM SYLVANIA's obligation under this warranty shall be limited to (at its option) repairing, replacing, or granting a credit at the prices invoiced at the time of shipment for any of said products. This warranty shall not apply to any such products which shall have been repaired or altered, except by OSRAM SYLVANIA, or which shall have been subjected. OSRAM SYLVANIA shall be liable under this warranty only if (A) OSRAM SYLVANIA receives notice of the alleged defect within sixty (60) days after the date of shipment; (B) the adjustment procedure hereinafter provided is followed, and (C) such products are, to OSRAM SYLVANIA’s satisfaction, determined to be defective. THE WARRANTY SET FORTH IN THE PRECEDING PARAGRAPH IS EXCLUSIVE AND IN LIEU OF ALL OTHER WARRANTIES, EXPRESS OR IMPLIED, INCLUDING, WITHOUT LIMITATION, ANY IMPLIED WARRANTY OF FITNESS FOR A PARTICULAR PURPOSE OR OF MERCHANTABILITY. The information contained in this manual is based on data considered to be true and accurate. Reasonable precautions for accuracy has been taken in the preparation of this manual, however OSRAM SYLVANIA assumes no responsibility for any omissions or errors, nor assumes any liability for damages that may result from the use of the product in accordance wit...
Otros modelos de este manual:Eléctrico - 065253 (82.55 kb)
Eléctrico - 070282 (82.55 kb)