Votos - 5, Puntuación media: 3.8
(
)
)
|
Resumen del manual
Pages 1-18 Optional Accessories ................................ Paragraphs 19-21 .. Pages 19-21 Check Installation and Start-Up ........................ Paragraph 22 .. Pages 22-23 Index By Page No. Belt Drive ............................................. 15 Blower Motor and Drive ...................... 15 Check/Test/Start-Up ............................. 22 Clearances ................................................ 2 Combustion Air ...................................... 4 Combustion Air Proving Switch ........... 15 Concentric Adapter ............................ 2, 5 Condensate Drain .......................... 14 Confined Space Installation .................. 10 Cased Cooling Coil (Model ACU) ..... 2, 19 Control Location Illustration ................. 15 Dimensions ............................................. 3 Index By Page No. Motor Amps ......................................... 16 Mounting the Heater .............................. 2 Start-Up ................................................. 22 Thermostat ........................................... 14 Uncrating and Preparation ...................... 2 Vent and Combustion Air ....................... 4 Determine Type of Vent ........................ 4 Power Vent Only Installation ......... 10-11 Separated-Combustion Installation ... 5-9 Warranty .................................................. 2 Wiring Diagrams .............................. 17-19 Index By Page No. Discharge Plenum (Optional) ............ 2, 21 Duct Connections ................................. 12 Electrical Supply and Connections ....... 14 Filter Cabinet (Optional) .................. 2, 20 Gas Piping and Pressures ..................... 13 Gas Valve .............................................. 16 General .................................................... 1 Hazard Intensity Levels ......................... 2 Ignition System ..................................... 16 Inlet Base (Optional) ......................... 2, 21 Installation Codes ................................... 2 Mixing Cabinet (Optional) .............. 2, 21 REFERENCES: Operation/Maintenance/Service Manual, Form RZ 405-OMS Installation Manual for Model ACU Cooling Coil, RZ 405-CC Gas Conversion Instructions for Model CAUA, RZ 405-GC Installation Manual for Optional Filter Cabinet, RZ 405-FC Installation Manual for Optional Mixing Box, RZ 405-MB Installation Instructions for Optional Inlet Base, RZ 405-IB Installation Instructions for Optional Discharge Plenum, RZ 405-DP FOR YOUR SAFETY What to do if you smell gas: • Do not try to light any appliance. • Do not touch any electrical switch; do not use any phone in your building. • Immediately call your gas supplier from a neighbor's phone. Follow the gas supplier's instructions. • If you cannot reach your gas supplier, call your fire department. WARNING: Improper installation, adjustment, alteration, service, or maintenance can cause property damage, injury, or death. Refer to this manual. For assistance or additional information, consult a qualified installer, service agency, or the gas supplier. WARNING: Gas-fired appliances are not designed for use in hazardous atmospheres containing flammable vapors or combustible dust. See Hazard Levels, page 2. FOR YOUR SAFETY Do not store or use gasoline or other flammable vapors and liquids in the vicinity of this or any other appliance. GENERAL Installation should be done by a qualified agency in accordance with the instructions in this manual and in compliance with all codes and requirements of authorities having jurisdiction. The instructions in this manual apply to the heater model shown below. Model Description CAUA Gas-Fired, Power-Vented, Vertical (Upflow) Heater Model CAUA heaters are design-certified by the Canadian Standards Association (CSA) to ANSI Z83.6 and CGA 2.6-M96 for industrial/ commercial installations in the United States and Canada. Heaters are available for use with either natural or propane gas. The type of gas, the firing rate, and the electrical characteristics are on the unit rating plate. A Model CAUA heater requires installation of an inlet air duct or an optional inlet air base and a supply duct or an optional discharge plenum. This heater may be installed as a separated-combustion system (taking combustion air from outside) or as a power-vented system (taking combustion air from the space where the heater is installed). Mfg No. 164771, Page 1 GENERAL (Cont'd) Separated-combustion units are designed to separate the air for combustion and the flue products from the environment of the building in which the unit is installed. Separated-combustion appliances are recommended for use in dust laden and some corrosive fume environments or in buildings with negative pressure (up to .15" w.c.). If installed as a separated-combustion system, the heater must be equipped with both combustion air and exhaust piping to the outdoors. All Model CAUA heaters must be vented to the outdoors. WARNING: Should overheating o...
Otros modelos de este manual:Eléctrico - RZ405 (1.27 mb)