Votos - 4, Puntuación media: 4.8
(
)
)
|
Resumen del manual
FOLLOW SHUTDOWN AND STORAGE INSTRUCTIONS TO TRANSPORT OR MOVE THIS APPLIANCE. Mr. Heater | Gas-Fired Infra-Red Portable Heater 4 Operating Instructions and Owner’s Manual 3. 3. A. WARNING: This heater is an unvented appliance and MUST be used ONLY in a well ventilated area. NEVER attempt to operate the heater inside any vehicle, camper or enclosure. B. Any combustion process requires and consumes oxygen, and will produce carbon monoxide. THIS HEATER MUST BE USED WITH ADEQUTATE VENTILATION. Do not use in a tightly enclosed area. Two openings directly to the outdoors MUST be provided. One HIGH and one LOW. Preferably on opposite sides of the enclosure. EACH OPENING SHALL HAVE A MINIMUM FREE AREA OF 24 SQUARE INCHES (6” X 4”). Structures of tight construction or tents using fire retardant materials will require larger openings. If any additional fuel burning appliances are operated, ALWAYS PROVIDE ADDITIONAL VENTILATION. Increase the area of each opening by at least 2 square inches for each 1,000 BTU’s per hour of additional input rating. C. WARNING: Provide ample ventilation. This heater consumes air (oxygen). Do not use this heater in unventilated structures to avoid endangering your life. Provide additional ventilation for any additional fuel-burning appliances and additional occupants. 4. MIMIMUM CLEARANCE FROM COMBUSTIBLE MATERIALS A. When operating, the heater surfaces are extremely hot. Keep sleeping bags, clothing, and all combustible materials clear of the heater by at least the distances shown in figure 4. B. WARNING: To avoid injury or property damage never allow clothing, tents or other combustible materials within 30” of the heater. This heater must be located at least 24” above the floor level when in use. Never operate the heater when sleeping. C. WARNING: Never direct the heat output of this heater toward any propane tank within 20 feet. BTU/HR. RATING NORMAL CLEARANCES TO COMBUSTIBLES MODEL NO. GAS PROPANE OPERATING PROCEDURE FROM C.L. OF HTR. TO FLOOR SIDES REAR CEILING MH12T and MH12TS 14,000 Vertical 24” 30" 30" 30” Figure 4 5. ASSEMBLY PROCEDURE A. Make sure the regulator knob on the heater is “off” by turning knob clockwise to the “OFF” position. B. Carefully screw POL nut directly into bulk 20 lb. propane cylinder, counterclockwise. REMEMBER – This is a left hand thread – see Figure 2. Make sure the heater is in a vertical upright position and directed away from the collar of the bulk tank. Use a 7/8” open end wrench to tighten the POL fitting – left hand thread – see Fig. 2. Mr. Heater | Gas-Fired Infra-Red Portable Heater 5 Operating Instructions and Owner’s Manual 6. 6. A. Before attempting to light the heater, check all fittings and connections with a soap solution. NEVER USE A MATCH TO CHECK FOR LEAKS. Should a gas leak occur, do not attempt to repair or use heater. Return the heater to your dealer or the address given on back page. B. Fuel – This heater must be used only with a vapor withdrawal LP gas bulk cylinder. THE BULK TANK MUST BE EQUIPPED WITH A STANDARD POL VALVE. WARNING USE HD.5 PROPANE GAS ONLY. DO NOT USE ANY OTHER TYPE FUEL. SEE YOUR PROPANE DEALER IF YOU HAVE ANY QUESTIONS REGARDING FUEL. C. Turn the heater’s “Hi-Med-Lo-Off” regulator knob to “Med” (counterclockwise). D. To light MH12T, place a lit match across the mesh screen where you see “light here” on reflector. (See Fig. 5) THEN push in valve button on Safety Shutoff Valve. After the heater is lit, continue to hold valve button in for 30 seconds, then release the button slowly. CAUTION: DO NOT PUSH IN VALVE BUTTON BEFORE INSERTING LIT MATCH. E. To light MH12TS, press “Sparklite” ignitor Safety Shutoff Valve button at the same time. (See Fig 5a) Prior to pressing "Sparklite" igniter. After the heater is lit, continue to hold valve button in for 30 seconds, then release the button slowly. F. If burner does not light within 30 seconds, turn the heater’s regulator knob to “off” (clockwise) and allow at least five minutes for gas to dissipate before attempting to relight. G. NOTE: Should the orifice become clogged as indicated by low volume of gas when operating on “Hi” with a full cylinder, or should the heater fail to operate properly for any reason, return the heater to the dealer or the address given on back page for repair or replacement. DO NOT ATTEMPT TO REPAIR OR TAMPER WITH HEATER. H. Adjust heat output by turning knob to desired position. I. COOKING: DO NOT USE THIS HEATER FOR COOKING. Figure 5 MODEL MH12T 7. SHUTDOWN AND STORAGE INSTRUCTIONS A. The bulk propane tank “on-off” valve should ALWAYS be completely turned “OFF” when the heater is not in use. B. When shutting off the heater, turn the regulator knob on the heater to “OFF” (clockwise). (See Figure 5 and 5a) C. CAUTION: After turning unit off, heater will remain extremely hot. Allow at least 15 minutes for cooling before handling and storing. Detach heater from bulk tank before handling and storage. REMEMBER – POL fitting is a left-hand thread. D. H...
Otros modelos de este manual:Eléctrico - MH12T (693.48 kb)