Votos - 3, Puntuación media: 3.7 ( )

Fabricar: Majestic Appliances Tamaño del archivo: 368.47 kb Nombre del archivo: Idioma del manual:

For elevations above 4,500 feet (1370m) consult local building codes. Nuisance outages may occur at altitudes above 4,500 feet (1370m) if dirt, dust, lint and/or cobwebs are allowed to accumulate on burner and/or ODS pilot. Monthly inspection and cleaning is recommended for altitudes above 4,500 feet (1370m). Vermont Castings Jefferson Vent Free Gas Heater General Information Vent Free Features Unpack the Stove The JUVS Gas Heater is an unvented gas appliance tested and listed to the ANSI standard Z21.11.2.2000. The Vent Free Gas Heater is configured to use Natural Gas, (JUVSRN, JUVSMN ) or Propane (JUVSRP, JUVSMP). Because these heaters are clean-burning and highly energy-efficient, no venting system is required. The JUVS is shipped fully assembled with the exception of the log set. The log set is assembled during installation. The JUVS is equipped with a Honeywell control valve that allows thermostatic control, on/off switch or a remote switch (not supplied). The JUVS model incorporates variable regulators that allow you to adjust burner heat output between HIGH, (28,000 BTU), and LOW, (20,000 BTU). See the Operation Section for details. The standing pilot incorporates an Oxygen Depletion System (ODS/pilot) which shuts off gas flow to the burner in the event that sufficient fresh air becomes unavailable for continued safe operation. PILOTADJ Safety Screen Supply Line Inlet OFF/ON/Pilot Control Knob Variable Regulator Gas Valve Piezo Ignitor ST100 Rear Log Bracket Pilot Hood & Pilot Rheostat Bracket Fig. 2 JUVS gas heater. Valve may be different. Remove the stove assembly from the shipping carton and inspect it for loose or damaged parts. Do not install this appliance if any parts are loose or if there is any visual or suspected damage resulting from shipping or handling. Report damage to your dealer/distributor immediately. The log set is packaged in the box shipped inside the firebox. To remove the packaged log set from the firebox: • Lift the stove front up and then swing the bottom out and away to disengage it from the stove body. (Fig. 3) Cut the wire tie securing the screen. • Remove the screen frame. (Fig. 4) • Remove box and set aside. Contact your dealer if the burner is loose or damaged in any way. ST229b Fig. 3 Remove stove front. ST208b Screen Hooks Fig. 4 Lift screen from firebox. Vermont Castings Jefferson Vent Free Gas Heater Installation Requirements Fresh Air Requirements for Combustion and Ventilation WARNING This heater must have fresh air for proper opera- tion. If it does not, poor fuel combustion could result. Read the following instructions to ensure proper fresh air supply for this and other fuel- burning appliances in your home. Modern construction standards have resulted in homes that are highly energy-efficient and that allow little heat loss. Your home needs to breathe, however, and all fuel-burning appliances need fresh air to function properly and safely. Exhaust fans, clothes dryers, fireplaces and other fuel burni...

Descargar ahora

Introduzca dos números de la imagen: