Votos - 3, Puntuación media: 4
(
)
)
|
Resumen del manual
PLEASE READ AND SAVE THESE IMPORTANT SAFETY INSTRUCTIONS THIS APPLIANCE HAS A POLARIzED PLUG (one blade is wider than theother). To reduce the risk of electric shock, this plug is intended to fit in apolarized outlet only one way. If the plug does not fit fully in the outlet, reverse the plug. If it still does not fit, contact a qualified electrician to install the proper outlet. DO NOT ATTEMPT TO MODIFY THIS PLUG OR DEFEAT THIS SAFETY FEATURE IN ANY WAY. In the U.S.A., this warranty is offered by Sunbeam Products, Inc. doing business Jarden Consumer Solutions located in Boca Raton, Florida 33431. In Canada, this warranty is offered by Sunbeam Corporation (Canada) Limited doing business as Jarden Consumer Solutions, located at 20 B Hereford Street, Brampton, Ontario L6Y 0M1. If you have any other problem or claim in connection with this product, please write our Consumer Service Department. PLEASE DO NOT RETURN THIS PRODUCT TO ANY OF THESE ADDRESSES OR TO THE PLACE OF PURCHASE. © 2011 Sunbeam Products, Inc. doing business as Jarden Consumer Solutions. All Rights Reserved. Distributed by Sunbeam Products, Inc. doing business as Jarden Consumer Solutions, Boca Raton, Florida 33431. Printed In China SPR-060111-495 P.N. 148576 ECO-SMART™ TECHNOLOGY ECO-SMART™ is a technology that allows this portable heater to heat an area more efficiently through a continuous cycling of wattages. Although no physical change is noticeable, when the heater runs in ECO-SMART™ mode it consumes less energy over a long period of time. To activate the Eco-Smart™ cycle depress the Eco-Smart™ button. The Eco-Smart™ cycle can be deactivated by depressing the Eco-Smart™ button. Once deactivated, the heater will run continuously at 1500 watts. PRE-OPERATING INSTRUCTIONS 1. Make sure the heater is OFF before plugging the heater into the outlet. 2. Place the heater on a firm, level surface. 3. Avoid overloading your circuit by not using other high wattage appliances in the same outlet. At 1500 Watts, this unit draws 12.5 Amps. 4. Make sure unit and plug is free of moisture and debris before plugging into an electrical outlet. CONTROL PANEL DETAILS (Figure 1) Control Panel: 1. Press the On/Off button to turn unit on. 2. Select temperature by pressing the Temperature button until the desired temperature is chosen. 3. Set the Timer for the duration in which you would like the heater to run before turning off automatically. 4. Then choose whether or not you would like to use the Eco- Smart™ Technology by pressing the Eco-Smart™ button. ON/OFF TIMER ECO-SMART™ SENSOR (NOT A BUTTON) TEMPERATURE Figure 1 FCC STATEMENT Potential for Radio/Television interference This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. This product has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. The product generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that the interference will not occur in a particular installation. If the product does cause harmful interference to radio or television reception, which can be determined by turning the product on or off, the user is encouraged to try to correct the interference by one or more of the following measures: • Reorient or relocate the receiving antenna. • Increase the separation between the product and the receiver. • Connect the product into an outlet on a circuit different from that to which the receiver is connected. • Consult the dealer or an experienced radio/TV technician for help. • Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. pure indoor living LOW PROFILE HEATER MODEL: BLP3340 Instruction Leaflet Read instructions before operating. Retain for future reference. Questions? Comments? Call 1-800-253-2764 in North America. OPERATING - INSTRUCTIONS CLEANING AND MAINTENANCE CLEANING/MAINTENANCE Always unplug the heater before cleaning and allow the heater to cool down. 1. Clean the unit with a soft cloth moistened with a mild soap solution. 2. NEVER use abrasive or flammable solvents to clean the unit. 3. After cleaning, be sure to completely dry the unit with a cloth or towel. 4. Store heater in a cool, dry location. 5. It is recommended that you store the unit in its original carton. TIP: Over time, dust may accumulate on the front grills. This can be removed by wiping the unit with a damp cloth. TROUBLESHOOTING If your heater fails to operate: • UNPLUG T...