Votos - 4, Puntuación media: 3.5
(
)
)
|
Resumen del manual
2. To stop oscillation, press the oscillation button again. 3. Please do not manually turn the heater on the base; it is designed to turn only by motorized oscillation. REMOTE CONTROL INSTRUCTIONS 1. Before operation, insert 2 “AAA” batteries into the back of the remote control. • Do not mix old and new batteries. • Do not mix alkaline, standard (carbon-zinc), or rechargeable (nickel-cadmium) batteries. The remote control for this unit has the capability of operating all control panel functions. Please note this remote control will not work through walls. POWER: To turn the unit on press the Mode/On Button. To turn the unit off press the OFF button. MODES: To scroll through the various modes LO, HI, AL and AH press the Mode Button until you reach your desired setting. OSCILLATION: To start oscillation, press the Osc. Button once. To stop oscillation press the button again. TEMPERATURE: To increase the temperature setting, press the Temp Up button. To decrease the temperature setting that you desire press the Temp Down button. TIMER: To activate the timer from the remote control, press the button marked Timer. From there you can press the Temp Up or Temp Down button, which will give you the ability to program the heater to turn on or off in 1 hour increments, up to 16 hours. For more information see the programmable timer instructions above. CLEANING/MAINTENANCE Removable Dust Filter: 1. Every few weeks, check the condition of the Filter on the rear side of the heater. 2. Remove the Filter Cover, and take the Filter out to flush gently with tap water from the inside face (Clean side) to remove the dirt and dust (See Fig. 3 & 4). 3. Drain excess water drip dry. 4. Resintall the Filter once it is dry, put back the Filter Cover in place. During Season Care: 1. Always unplug the heater before cleaning. 2. Clean the unit with a soft cloth moistened with a mild soap solution. 3. NEVER use abrasive or flammable solvents to clean the unit. 4. After cleaning, be sure to completely dry the unit with a cloth or towel. After Season Care: 1. Store heater in a cool, dry location. 2. The manufacturer recommends that you store the unit in its original carton. .TIP: Over time, dust may accumulate on the front grills. This can be removed by wiping the unit with a damp cloth. Always unplug unit and allow to cool prior to cleaning. TROUBLESHOOTING If your heater fails to operate: • UNPLUG THE UNIT. • Make sure the electrical outlet or circuit breaker is working. • Check for obstructions. If you find an obstruction turn the heater OFF, and unplug the unit. Carefully remove the obstruction and follow the reset instructions. • The temperature may be set too low. Adjust the thermostat until the heater restarts. Please DO NOT attempt to open or repair the heater. Please see the Warranty for Service Instructions. This heater is equipped with a patented, technologically advanced safety system that requires the user to reset the heater if there is a potential overheat situation. When a potential overheat temperature is reached, the system will automatically shut the heater off. It can only resume operation when the user resets the unit. To Reset the Heater: 1. Unplug the heater and wait 10 minutes for the unit to cool down. 2. After the 10 minutes, plug the unit in again and operate normally. Tip-Over Shut-Off: When the unit is accidentally knocked over, it will instantly shut off. To reset, simply place the heater in an upright position. Press the MODE button and it will operate normally. PRE-OPERATING INSTRUCTIONS 1. Carefully remove your heater from the box. Please save the carton for off-season storage. 2. Make sure the unit is in the OFF position before plugging the heater into the outlet. 3. Place heater on a firm level surface. 4. Avoid overloading your circuit by not using other high wattage appliances in the same outlet. At 1500 Watts, this unit draws 12.5 Amps. NOTE: The power light will illuminate when the heater is turned on. DIGITAL THERMOSTAT Your heater is equipped with a Digital Thermostat that allows you to set your heater to your precise comfort level. SETTING THE DIGITAL THERMOSTAT: 1. Press the Mode Button once for manual HI power. The heater will run continuously on HI. 2. Press the Mode Button again for manual LO power. The heater will run continuously on LO. 3. Press the Mode Button for a third time for Auto Mode HI Power (AH) or press again for Auto Mode LO Power (AL). In either of these modes you may then press the up, and down buttons to reach your desired temperature. Fig.1 Control Panel Close-up MODE BUTTON OSCILLATION BUTTON TEMP/TIMER UP BUTTON TEMP/TIMER Read instructions before operating. DOWN BUTTON Retain for future reference. Instruction Leaflet INFO-LINE If after having read this leaflet, you have any questions or comments on your heater, call 1-800-253-2764 in North America. 129340 . 5 YEAR LIMITED WARRANTY Sunbeam Products, Inc. doing business as Jarden Consumer Solutions or if in Canada, Sunbeam C...