Votos - 3, Puntuación media: 4.3
(
)
)
|
Resumen del manual
3. This heater has three heat control settings OFF, ”LOW” HEAT AND “HIGH” HEAT, located at the top of the unit, along with an adjustable thermostat control. “LOW” HEAT (750W) is the lowest heat setting and “HIGH” HEAT (1500W) is the highest. 4. To select these settings DO NOT twist or rotate the heat control and thermostat control located on the top of the heater. To turn the heater on, grip the heat setting knob and lightly pull all the way up to the “HIGH” setting. There will be an audible click as the wedge moves through the settings. The power indicator light will illuminate to indicate that power is on. 5. To decrease the heat settings push down on the heat control. There will be an audible click as the wedge moves through the settings. 6. To turn the heater OFF push the heat control (used to select “LOW” HEAT or “HIGH” HEAT settings) all the way down and the heater will turn off. The power indicator light will go out. Thermostat control Turn the heat control to the HIGH setting by pulling the knob up. Pull up the thermostat control to the highest thermostat setting. Let the heater run until the desired room temperature is achieved.Then push the knob down until you hear a click sound.The unit will stop.At this setting, your heater will automatically cycle on and off to maintain the desired room temperature. Once the thermostat is activaed, you can simply pull the knob up or down if you want to change the temperature. Thermo Guard Overheating Safety Device Your heater is fitted with a safety device that switches off the heater in the event of overheating. Should this heater stop working, turn off the heater and inspect for blockages in air inlet or outlets.Wait at least five minutes for the protection system to reset before attempting to restart the heater. If the heater fails to operate or the safety device switches off again, return the heater to your nearest service centre for examination or repair. CARE AND MAINTENANCE • Always turn off and then unplug the heater before cleaning • Use only a clean, dry cloth to clean the external surfaces of the heater only. • If the heater has collected dust or dirt inside the unit or around the elements, have the unit cleaned by a qualified service agent. Do not operate the heater in this condition. • Do not attempt to open the case of the heater at any time there are no customer serviceable parts inside. • When not in use, pack the heater, preferably in its original box for best protection and store in a cool, clean and dry location. • The air filter at the rear of the heater can be easily cleaned by removing the filter casing panel and removing the mesh filter.A basic clean in warm water to remove any build up is adequate and allow time to completely dry before replacing the filter and the filter casing panel. KAMBROOK 12 MONTH REPLACEMENT WARRANTY Kambrook warrants the purchaser against defects If the product includes one or a number of in workmanship and material for a period of 12 accessories only the defective accessory months from the date of purchase (3 months or product will be replaced. In the event of commercial use). Kambrook choosing to replace the appliance, the guarantee will expire at the original date, i.e. 12 Guarantee and purchase receipt for this product months from the original date of purchase. are to be retained as proof of purchase and must be presented if making a claim under the In Australia, this KAMBROOK Guarantee is Kambrook guarantee. additional to the conditions and guarantees which are mandatory as implied by the Trade Practises Kambrook reserves the right to replace or repair Act 1974 and State and Territory legislation. the appliance within the warranty period, For service, spare parts or product information Warranty does not apply to any defect, in Australia, please call KAMBROOK on the deterioration, loss, injury or damage occasioned Customer Service Line; 1300 139 798. by, or as a result of the misuse or abuse, negligent handling or if the product has not been used in For service, spare parts or product information accordance with the instructions. The guarantee in New Zealand, please call KAMBROOK New excludes breakages and consumable items such as Zealand; 0800 273 845. For spare parts phone kneading blades. 0800 273 845. This warranty is void if there is evidence of the If claiming this guarantee the product must be product being tampered with by unauthorised returned freight prepaid. persons. KAMBROOK 12 MONTH REPLACEMENT WARRANTY Attach a copy of the purchase receipt here. YOUR PURCHASE RECORD (Please complete) DATE OF PURCHASE ___________________ MODEL NUMBER ______________________ SERIAL NUMBER ______________________ (Please don’t return purchase record until PURCHASED FROM ____________________ you are making a claim) Register your warranty at Kambrook - Australia 461 Plummer Street, Port Melbourne, 3207, Australia Customer Service Line 1300 139 798 Customer Service Fax 1800 621337 Kambroo...