Votos - 3, Puntuación media: 3.3 ( )

Fabricar: FireplaceXtrordinair Tamaño del archivo: 601.91 kb Nombre del archivo: 17601478.pdf Idioma del manual:

If this face is replacing a Lopi Grill (96200801). make sure to replace the center deflectors. Installation Details - 564 SS SIDE OF FIREPLACE L 0” TO 1” NOTE: This face has an adjustable bracket that allows for different facing depths to be tucked under the face. 1 Page 1 of 6 7/19/G7 © Travis Industries, Inc. RREPLACE 564 SS / 564 E Rectangular Face Xtrordinair» Black 95400411 Nickel 95400413 mí>m 564 SS / 564 E Rectangular Face Black 95400411 Nickel 95400413 Installation - 564 SS (continued) 3 Install the face following the directions below. Plated Surfaces Use denatured alcohol and a soft cloth to clean plated surfaces. Marks left on the surface may damage the face. \ Soft Cloth A Denatured Alcohol Page 4 of 6 7/19/07 © Travis Industries, Inc. Fireplace Xtrordlnair» ímA^íní>m 564 SS / 564 E Rectangular Face Black 95400411 Nickel 95400413 Installation - 564 Electric 1 Install the upper heat shield onto the 564 E fireplace. Place the upper heat shield included with this kit on top of the fireplace (note position of heat shield). Place the stock heat shield on top of it and secure with the same screws. Page 5 of 6 7/19/07 © Travis Industries, Inc. Fireplace IXtrordlnair» ímA^íní>m 564 SS / 564 E Rectangular Face Black 95400411 Nickel 95400413 2 Place the face, face down, on a soft, non-scratching surface. Install the 564 Electric mounting brackets onto the back of the face. Remove and discard the hinge assembly from the face. Attach the upper 564 E bracket (and shim). Use the nuts included with this kit. Attach the lower 564 E bracket (and shim). Use the nuts removed earlier and one of the nuts included with this kit. Repeat steps “a” through “c” for the opposite side. Before installing the face verify the lower grill is centered. Loosen the nuts and adjust if necessary. 3 Pull the electric fireplace out of the mantel (or built-in location). Attach the cove covers and face following the directions below. Slide the fireplace back into place to complete the installation. Lift the face up slightly, tilt it forward and insert the top hooks until the face locks in place. Tilt the face back slightly and insert the bottom hooks into the slots on the fireplace. Page 6 of 6 7/19/07 © Travis Industries, Inc....

Descargar ahora

Introduzca dos números de la imagen: