Votos - 3, Puntuación media: 4.3 ( )

Fabricar: Lennox Hearth Tamaño del archivo: 2.39 mb Nombre del archivo: Idioma del manual:

When positioned properly as shown, logs will be positioned between fl ame peaks and will not impinge any fl ames. Refer to Figure 26 for MPB33 Series appliances, Figure 27 for MPB35 Series appliances and Figure 28 for MPB40 and MPB45 Series appliances. NOTE: Turn off all electricity to the appliance before you install volcanic stone, embers and logs. NOTE: DIAGRAMS & ILLUSTRATIONS ARE NOT TO SCALE. WARNING • DO NOT attempt to install the logs until the appliance installation has been completed, the gas line connected and tested for leaks and the initial burner operation has been checked out. •The size and position of the log set was engineered to give the appliance a safe, reliable and attractive flame pattern. Any attempt to use a different log set in the fi replace will void the warranty and will result in incomplete combustion, sooting, and poor fl ame quality. • Logs get very hot and will remain hot up to one hour after gas supply is turned off. Handle only when logs are cool. Turn off all electricity to the appliance before you install grate, volcanic stone, embers and logs. •This appliance is not designed to burn wood. Any attempt to do so could cause irreparable damage to the appliance and prove hazardous to your safety. •If logs are not installed according to the log installation instructions, flame impingement and improper combustion could occur and result in soot and/or excessive production of carbon monoxide (CO), a colorless, odorless, toxic gas. LENNOX HEARTH PRODUCTS • MERIT PLUS® B-VENT GAS FIREPLACES (MPB33/35/40/45) • INSTALLATION INSTRUCTIONS Step 1. Remove the appliance front door (see Removing the Glass Enclosure Panel on Page 19). Step 2. Install decorative volcanic stone—Sprinkle the decorative volcanic stone in a pleasing pattern. The volcanic stone should be placed directly on top of the firebox bottom, along the front and to the back at the right and left sides of the burner. Position any optional ceramic fiber liners before placing the stone. Logs should be positioned after the volcanic stone. Note: This appliance is provided with enough glowing embers for several applications, do not feel compelled to use all that is in a new bag. For best glowing effect, replace the ember material annually. Replacement glowing embers are available (Catalog Number 88L53). Glowing Embers Bag of Glowing Embers (rockwool) Separate into Quarter Size (separate) Pieces Figure 24: Step 3. Separate the glowing embers (rockwool) into pieces about the size of a quarter (see Figure 24). Keep the pieces fluffed up, not matted. Distribute these pieces over the front surface of the burner, as shown in Figure 25. Do not use more than is necessary. When properly positioned, the Glowing Embers will cover approximately 65% of the front burner and with no appreciable gaps or openings. Ensure that the main burner ports remain uncovered by the ember material. Step 4. Placement of Logs—All toplogs that rest on lower logs, do so overnotches, indents or nubs. ...

Descargar ahora

Introduzca dos números de la imagen: