Votos - 1, Puntuación media: 4
(
)
)
|
Resumen del manual
No Model Description REV. NC 06/2008 H5775 ADAGIO-IG Garden Gate, Vintage Iron Facade H5776 ADAGIO-CPD Garden Gate, Vintage Copper Facade INSTALLATION INSTRUCTIONS FOR FACADE KITS FOR USE WITH ADAGIO™ DIRECT-VENT GAS FIREPLACES DAVE LENNOX COLLECTION KIT CONTENTS: 1 ea. Facade Assembly 1 ea. Left Gate 1 ea. Right Gate TOOLS / SUPPLIES NEEDED: None Iron Garden Gate Facade Copper Garden Gate Facade Installer: Leave This Instruction Sheet With The Appliance. Consumer: Retain This Instruction Sheet For Future Reference. GENERAL INFORMATION These decorative facade kits are offered in two attractive styles, Iron Garden Gate and Copper Garden Gate. If you encounter any problems or need clarification of these instructions, contact you local distributor or dealer. Note: The framing of the appliance will need to be elevated by 3/4" minimum above the floor to allow for the proper fit of the facade (i.e. 3/4" board as platform). See Installation Instructions Manual. INSTALL ONLY WHEN FIREPLACE IS OFF AND COOL. Back of Facade Shown Figure 1 - Kit Contents ALL WARNINGS, PRECAUTIONS AND INSTRUCTIONS PROVIDED IN THE INSTALLATION INSTRUCTIONS MANUAL AND THE CARE AND OPERATION MANUAL PROVIDED WITH THE APPLIANCE APPLY TO THESE INSTRUCTIONS. THOROUGHLY READ AND FOLLOW THE INSTRUCTIONS PROVIDED WITH THE APPLIANCE BEFORE PROCEEDING TO THE FOLLOWING INSTRUCTIONS. INSTALLATION INSTRUCTIONS 1. Install the appliance, firebox liner and logs per the Installation Instructions Manual provided with appliance and the Installation Instruction Sheet provided with the firebox liner kit (sold separately). NOTE: DIAGRAMS & ILLUSTRATIONS ARE NOT TO SCALE. 1 2. Install the facade onto the fireplace face per instructions in Figure 2. Align the tabs on the bracket assemblies all the way into the slots on fireplace, then push facade down to ensure engagement. Slots on Fireplace (2 places each side) Note: There are two mounting positions on the facade hanging brackets to better accommodate a range of facing thicknesses. Adjust to the notch on the hanging bracket that works best for your installation. Figure 2 - Install Facade 3. Install the left and right side gates as shown in Figures 3 and 4. The hinges on the gates hang on the hinge pins on the facade. Figure 3 - Align Door Hinges Over Facade Hinge Pins Tabs on Bracket Assemblies (2 places each side) Figure 4 - Lower Door Over Pins Until Fully Seated 4. See Figure 5 for instructions on accessing the control compartment. The gated doors must be open to access the control compartment door. To open; pull doors open until magnet latches release. To open, pull the hinged door forward and down as shown. To close, hinge the door closed until magnets secure it in place. Figure 5 - Opening the Control Compartment Door Completed Installation Figure 6 NOTE: DIAGRAMS & ILLUSTRATIONS ARE NOT TO SCALE. Lennox Hearth Products reserves the right to make changes at any time, without notice, in design, materials,...
Otros modelos de este manual:chimeneas - ADAGIO-IG H5775 (265.65 kb)