Votos - 2, Puntuación media: 3.5
(
)
)
|
Resumen del manual
It is important that control compart- ments, burners and circulating air passage- ways of the appliance be kept clean. 4. Always turn off gas to the pilot (millivolt appliances) and let the unit cool down before cleaning. Before re-lighting, refer to the light- ing instructions in this manual. Lighting instructions may also be found on the pull out lighting instruction labels attached to the gas control valve. 5. Always keep the appliance area clear and free from combustible materials, gasoline and other flammable liquids. 6. Remember, Millivolt appliances have a con- tinuous burning pilot flame. Exercise caution when using products with combustible vapors. Glass Cleaning It will be necessary to clean the glass periodi- cally. During start-up it is normal for conden- sation to form on the inside of the glass. This can cause lint, dust and other airborne par- ticles to cling to the glass surface. Also initial paint curing may deposit a slight film on the glass. It is therefore recommended that the glass be cleaned two or three times with a non- ammonia household cleaner and warm water (a gas fireplace glass cleaner is recommended). After that the glass should be cleaned two or three times during each heating season, de- pending on the circumstances present. Figure 2 Millivolt Gas Valve Variable Flame Height Adjustment ( Millivolt Appliances only) 1. All Millivolt appliances are equipped with a variable gas control valve. Flame height for these models may be adjusted through a range be- tween fixed low and high settings while the appliance is in operation. Adjust the flame height as desired after lighting the appliance by rotating the variable adjustment control knob located on the front of the valve (refer to Figure 2). HI LOW TPTH TP TH PILOT PILOTON it OFF Variable Flame Height Adjustment Manifold Pressure Port Inlet Pressure Port Main Gas Control Knob IN OUT Optional Burner ON/OFF Rocker Switch Location Factory-Installed Blower ON/OFFRocker Switch Location Piezo Ignitor ON/OFF Switch Electronic Gas Control Valve Inlet Pressure Port Manifold Pressure Port OFFINPSI ONCONTROL IGNITER WARNING: DO NOT USE ABRASIVE CLEANERS. NEVER CLEAN THE GLASS WHEN IT IS HOT. CAUTION: DO NOT TOUCH THE FRONT ENCLOSURE GLASS WITH YOUR HANDS WHILE THE FIREPLACE IS IN USE. Maintenance The appliance and venting system should be thoroughly inspected before initial use and at least annually by a qualified service technician. However, more frequent periodic inspections and cleanings should be performed by the homeowner. Homeowner must contact a qualified service technician at once if any abnormal condition is observed. Refer to the maintenance schedule for maintenance tasks, procedures, periodicity and by whom they should be performed. Always verify proper operation of the appliance after servicing. IMPORTANT: TURN OFF GAS AND ANY ELECTRICAL POWER BEFORE SERVICING THE APPLIANCE. Glass Enclosure Panels - Removal and Installation. WARNING: NEVER OPERATE THE APPLIANCE WITHOU...
Otros modelos de este manual:chimeneas - NEC-FPDC (1.49 mb)
chimeneas - NEC-FPDC (1.49 mb)
chimeneas - NEC-FPDC (1.49 mb)
chimeneas - NEC-LCDC (1.49 mb)