Votos - 4, Puntuación media: 3.8 ( )

Fabricar: Ultra Products Tamaño del archivo: 43.96 kb Nombre del archivo: 04-0233d.pdf Idioma del manual:

2. Unplug the power cord from the back of the computer. 3. Remove your computer’s cover. 4. Remove the slot bracket from an available PCI slot. 5. To install the card, carefully align the card's bus connector with the selected PCI slot on the motherboard. Push the board down firmly, but gently, until it is well seated. 6. Replace the slot bracket's holding screw to secure the card. Device Connection The UltraATA 133 PCI is a dual channel Ultra ATA/133 controller that supports up to four IDE hard disk drives or ATAPI devices. If you plan to use the second IDE channel (IDE2). In order to achieve high-speed data transfer, a 40-pin/80wire Ultra ATA ribbon cable is recommended. Also, do not mix Ultra ATA/133 hard disk with slower IDE or ATAPI devices on the same channel. 1. Install hard disk drive(s) in chassis. 2. Attach one connector on the long end of the Ultra ATA ribbon cable to the board's IDE connector and the other connector(s) to your IDE drive(s). Make sure pin 1 on the cable (indicated by the colored stripe) matches pin 1 on the board's IDE connector and your IDE drive(s). 3. When two drives are installed on the same IDE channel, make sure one drive is set up as Master and the other as Slave. This rule applies to both IDE channels. 4. The Ultra ATA ribbon cable has two connectors. If you install only one drive, connect it to the end connector of the cable. On the other hand, if you install two drives, connect the master drive to the end connector of the cable and the slave drive in the middle connector. Figure 2. Connecting the cable 5. Reconnect the system power and other peripherals to your computer. Driver Installation This section provides information on how to install the UltraATA 133 PCI drivers for the following operating systems: Windows 98SE...........................................................page 5 Windows ME ............................................................. page 6 Verify Windows 98SE/ME Installation ..............page 6-7 Windows NT 4.0 ....................................................... page 7 Verify Windows NT 4.0 Installation ...................... page 8 Windows 2000 ........................................................... page 8 Windows XP/Server 2003 ....................................... page 9 Verify Windows 2000/XP/2003 Installation ...... page 10 Bios Configuration..................................................page 10 Windows 98SE Windows 98SE 1. Install the board and follow Microsoft procedures to install Windows 98SE accordingly. 2. Once Windows has been installed, right click My Computer and click Properties. Select Device Manager tab. 3. Double click PCI Mass Storage Controller listed under Other Devices. 4. Select Driver tab, then click Update Driver button. 5. Insert the driver diskette and click Next. 6. Select Search for a better driver ... and click Next. 7. Check Floppy disk drives, uncheck the other boxes, then click Next. Click Next again, then Finish. 8. Remove the driver disket...

Descargar ahora

Introduzca dos números de la imagen: