• You are in an area which has network coverage. E-mail: mobile@zte.com.cn party products provided that such defects is due to the combined usage. 5. ON/OFF: Turn the router ON or OFF. the router will not work. 1 2 3 4 5 6 7 8 9 Select Settings > Advanced Change the Administrator Settings, restore factory defaults, manage PIN, LAN Interface Setup, upgrade the software, SNTP or set TR069 configuration. Select Settings > Advanced Change the Administrator Settings, restore factory defaults, manage PIN, LAN Interface Setup, upgrade the software, SNTP or set TR069 configuration. 6. Input User Name and Password. The default User Name is admin, Voice Preparation Notes: Accessing the WebGUI Configuration Page When you login, the following interface appears. WAN Connection • Please check the label on your device to get the default SSID. Password is admin. Then you can view storage devices. Establishing a connection between your device and • The default setting of the device is no encryption. The client can connect 1. Make sure the connection between your device and the client is correct. In Cable Broadband mode Making a Call 2. Launch the internet browser and enter in the address Logout with the device directly. Click WAN Connection, you can configure how to connect to the Internet. the client Notes: Make sure that you can remember the new password if you change You can only make a call through VoIP. • You can set the security mode and password on Settings > Wi-Fi bar. Select Logout, a pop-up window will appear as the following figure shown: the login password by selecting Settings > Advanced > Management. To make a call: Via RJ45 Ethernet cable Notes: It is recommended that you use IE (7.0 and later), Firefox (5.5 or Settings > Security. Then there will be a pop-up window to require Please restore the device to the factory default settings in case you forget the new password. 1. Pick up the handset. 1. Connect your device and the client with the RJ45 Ethernet cable. the password. Please remember the password you set. If you forget later), Opera (11.11or later), Safari (5.1 or later) or Chrome (11.0 or later). 2. Key in the telephone number. 2. Power on your device. the password, you can connect the device with the computer by RJ45 3. The login page appears as follows. 3. You can either press # key on the telephone to send the call, or wait 4 ~ The connection between your device and the client will be established Ethernet cable to view the password on Settings > Wi-Fi Settings > Usage of WPS 8 seconds for the call to be connected automatically. successfully a moment later. Security. If your client device supports WPS, you need not to input the password 4. Call will be connected. 4. Wait a moment, the connection between your device and the client will Via Wi-Fi The line is noisy/ distorted when I lift the phone off the hoo...