Votos - 4, Puntuación media: 3.5 ( )

Fabricar: Acer Tamaño del archivo: 925.96 kb Nombre del archivo: Idioma del manual:

Connecting peripherals After everything is connected, plug the power cord into the system and insert the other end into a power outlet. Note: Don't connect the system power cord before connecting all peripherals to the system. Starting your computer After connecting all the peripheral equipment, start your computer according to the steps below: 1 Turn on all peripheral equipment, such as the monitor, printer, fax, speakers, etc. 2 Turn on the system. Once the start up process is complete, you can begin to use your computer. Shutting down your computer From the "Start" menu, select "Shut Down" and click OK. In the event of a system crash, press and hold the power button on the front of the system for four seconds. After the system has shut down, turn off all peripheral devices. English EnglishEnglish 4 Setting up your computer System upgrade You can expand your AcerSystem system quickly and easily by adding components. You can also upgrade the components of your AcerSystem system. Opening the computer Before removing any panels or covers, please make sure to shut off the computer and unplug the power cord from the outlet. • Remove the screws on the chassis. • Slide the panel off. Setting up new components You can only use components compatible with AcerSystem computers. Before you choose new components, please ask your authorized Acer dealer whether the part will operate within your AcerSystem system. In order to ensure proper setup and installation, please refer to the instructions provided with your new components. Probable upgrades are: -Upgrade to high-capacity HDD -Expand high-level memory -Upgrade from a CD-ROM drive to CD-RW, DVD-ROM, DVD/CD RW combo or DVD write (selected models only)r -Install additional interface cards in empty PCI slots, e.g., PCI fax/modem card (selected models only) 5 Frequently asked questions The following questions are possible situations that may arise during the use of your computer and each is followed by easy answers and solutions to the situation. Q: I pressed the power switch but the system did not boot up. A: Check the LED located above the power switch. If the LED is not lit, no power is being applied to the system. Do any of the following: • Check if the voltage selector switch located on the rear panel of the computer is set to the correct voltage. • Check if you plugged the power cable properly into an electrical outlet. • If you are using a power strip or AVR, make sure that it is plugged in and turned on. If the LED is lit, check the following: • Is a non-bootable (non-system) diskette in the floppy drive? If yes, remove or replace it with a system diskette and press Ctrl + Alt + Del to restart your computer. • The operating system files may be damaged or missing. Insert the startup disk you created during Windows setup into the floppy drive and press Ctrl + Alt + Del to restart your computer. This will automatically diagnose your system and make necessary fixes. However, if the diagnostic utility stil...

Descargar ahora

Introduzca dos números de la imagen: