Votos - 3, Puntuación media: 3.7
(
)
)
|
Resumen del manual
If you are installing or removing a PCI card from PCI slot 6 or 7, see page 76 for more information. Cards can be hot-plugged in PCI slots 1 through 5. You can remove and replace a PCI card with OS hot-plug interface. Removing hot-plug PCI card To remove a hot-plug PCI card with OS hot-plug interface: 1 Observe the ESD precautions described on page 33. 2 If you are using a Microsoft Windows operating system, double- click the Unplug/Eject icon in the taskbar to open the Unplug or Eject Hardware menu. 3 Select the device to be removed and click Stop. 4 Make sure that the power LED on the rear of the PCI slot is turned off before disconnecting any cables attached to the card. 5 Rotate the slot retention latch on the rear of the card slot upward (A). 6 Pull up the card to remove it (B). 7 Store the card in an antistatic protective wrapper. 3 System upgrade Install the slot cover over the empty slot, then rotate the retention latch downward (C). 9 Observe the post-installation instructions described on page 34. Installing a hot-plug PCI card 1 If your server is operating, use your OS to power down the PCI slot. 2 Observe the ESD precautions described on page 33. 3 Locate an empty expansion slot on the mainboard. 4 Rotate the slot retention latch on the rear of the card slot upward. 5 Pull up the slot cover. 6 Remove the PCI add-in board from its protective packaging. 7 Align the card in the empty slot. 8 Insert the card into the selected slot. Make sure that the card is properly seated. 9 Rotate the retention latch downward. 10 Connect any required cable to the card. 11 When using the hot-plug PCI card with OS hot-plug interface: • Wait for the software user interface to appear on your monitor and then confirm the device to be enabled. • Wait for the power LED to turn on. Configuring cold-pluggable components Cold-pluggable components are the components that require the system to be powered down before you can remove or replace them. The cold-pluggable components installed in the server include: • DVD drive • 5.25-inch drive • Processor • Processor core VRMs • Memory board • DIMM modules • PCI card • ARMC/3 or BMC module 3 System upgrade DVD drive Removing the DVD drive 1 Observe the ESD precautions and pre-installation instructions described on page 33. 2 Disconnect the power and SATA cables from the SATA-to-IDE converter board on the rear of the media device (A). 3 Press the blue release latch on the media device carrier (B). 4 Slide the media device from the front opening in the faceplate of the system (C). Installing the DVD drive 1 Observe the ESD precautions and pre-installation instructions described on page 33. 2 If necessary, remove the old DVD drive. See previous section. 3 Lift the rear right corner of the media device to remove it from the carrier (A) and (B). 4 Remove the SATA-to-IDE converter board (C). 5 Remove the new drive from its protective packaging. 6 At...
Otros modelos de este manual:Computadoras - Altos R910 Series (5.06 mb)