Votos - 1, Puntuación media: 3
(
)
)
|
Resumen del manual
The LED (light) will illuminate after 250 hours of operation. To reset after cleaning the filter, press the “Check Filter” button and the light will go off. CLEAN AIR FEATURE (on some models): DO THIS: PRESS CLEAN AIR BUTTON YOU WILL SEE: LIGHT On Note: When this feature is “ON”, the electronic air purifier is energized to remove pollen and impurities from the air. To cancel this feature, press the Clean Air button (the LIGHT will turn off). 9 ■■■■■■ 4 PlO.pdf 1/20/2007 4:12:29PM 4 n 4- II 4- 4- Air Conditioner Features (continued) REMOTE SENSING/FOLLOW ME FEATURE (on some models) : LIGHT pulsing On & Off intermittently. DO THIS: PRESS REMOTE SENSING/FOLLOW ME BUTTON ON NOTE: Unit display shows “set” temperature NOTE: Remote display is actual temperature at remote control only Note: This feature can be activated from the remote control ONLY, the unit must be in a cooling mode. To activate the remote sensing feature, point the remote control towards the unit and press the remote sensing button. Next, use the A. ▼ buttons to set the desired temperature at the remote. (Note that the set temperature will only be displayed on the unit itself). The LIGHT on the unit control will pulse to indicate it received the signal. The LIGHT on the remote control will pulse each time it sends a signal. It will continue to send this signal until the feature is deactivated by pressing the remote sensing button. If the unit does not receive the remote sensing signal during any 3 minute interval, the unitwill beep to indicate the remote sensing mode has ended. The display on the remote control indicates the temperature at the remote ONLY. The unit display indicates the set temperature. FAULT CODES If the display reads “AS” or “ED”, a sensor has failed. Contact your Authorized Frigidaire Service Center. TO TURN UNITOFF: WARNING CODES In the fan mode if “LO” or “HI” is displayed, this means the room temperature is outside the unit set points of 99°F/37°C (HI) or 32°F/0°C (LO). YOU WILL SEE: 10 4 4 I« 4 Pll.pdf 1/18/2007 2:04:00AM A‘ A Air Conditioner Features (continued) ADDITIONAL THINGS YOU SHOULD KNOW Now that you have mastered the operating procedure, here are more features in your control that you should become familiar with The “Cool “ circuit has an automatic 3 minute time delayed start if the unit is turned off and on quickly. This prevents overheating of the compressor and possible circuit breaker tripping. The fan will continue to run during this time. The control will maintain the set temperature within 2 degrees Fahrenheit, between 62°F(17°C) and 86°F(30°C) degrees. The control is capable of displaying temperature in degrees Fahrenheit or degrees Celsius. To convert from one to the other and back, press and hold the “TEMP/TIMER” Up ) and Down ) buttons together for 3 seconds. 4-Air Directional Louvers The 4-Way air directional louvers allow you to direct the air flow Up or Down and Left or Right throughout the room as needed. To adjust the air directional louvers side-to-side, use the center handles as you move it side-to-side. (4-WAY) Care and Cleaning Clean your air conditioner occasionally to keep it looking new. Be sure to unplug the unit before cleaning to prevent shock or fire hazards. Air Filter Cleaning The air filter should be checked at least once a month to see if cleaning is necessary. Trapped particles in the filter can build up and cause an accumulation of frost on the cooling coils. ♦ Grasp the filter by the center and pull up and out. ♦ Wash the filter using liquid dishwashing detergent and warm water. Rinse filter thoroughly. Gently shake excess water from the filter. Be sure filter is thoroughly dry before replacing. ♦ Or, instead of washing you may vacuum the filter clean. Cabinet Cleaning ♦ Be sure to unplug the air conditioner to prevent shock or fire hazard. The cabinet and front may be dusted with an oil-free cloth or washed with a cloth dampened in a solution ofwarm water and mild liquid dishwashing detergent. Rinse thoroughly and wipe dry. ♦ Never use harsh cleaners, wax or polish on the cabinet front. ♦ Be sure to wring excess water from the cloth before wiping around the controls. Excess water in or around the controls may cause damage to the air conditioner. ♦ Plug in air conditioner. Winter Storage If you plan to store the air conditioner during the winter, remove it carefully from the window according to the installation instructions. Cover it with plastic or return it to the original carton. NOTE: To prevent rust or electrical connections from being damaged, store air conditioner in an upright position and a dry place. Energy Saving Ideas Do not block air flow inside with blinds, curtains or furniture; or outside with shrubs, enclosures, or other buildings. The capacity of the room air conditioner must fit the room size for efficient and satisfactory operation. Install the room air conditioner on the shady side of your h...