Votos - 2, Puntuación media: 4.5 ( )

Fabricar: Kenmore Tamaño del archivo: 744.68 kb Nombre del archivo: Idioma del manual:

Power Supply • Switch off the power supply beforecleaning or servicing. • Turn off the power supply if theunit is not used for a long periodof time. • This air conditioner is equippedwith a built-in surge protectivedevice. However, in orderto further protect your airconditioner from being damagedby abnormally strong lightningactivity, you may want todisconnect it from the powersupply. Do not touch the airconditioner during lightning, it maycause electric shock. Outdoor Unit • Do not sit or place anything onthe indoor or outdoor unit. • Do not touch the sharp aluminiumfin. • Ensure that the drainage pipe isconnected properly. Otherwise, leakage may occur. • After long periods of use, makesure the installation rack is not damaged. Outdoor Unit • Do not insert your fingers or other objectsinto the unit. AiAir inlet AirAir outletoutlet Air outlet Air inlet Air inlet REGULATORY INFORMATIONREGULATORY INFORMATION REGULATORY INFORMATIONREGULATORY INFORMATION Thank you for purchasing Air Conditioner This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety. Children should be supervised to ensure that they do not play with the appliance. OPERATION CONDITIONOPERATION CONDITION Use this air conditioner under the following temperature range Temperature (°C) Maximum Minimum Maximum Minimum Indoor Outdoor *DBT *WBT *DBT *WBT COOLING 32 23 43 26 16 11 16 11 HEATING 30 -24 18 16 --5 -6 * DBT: Dry bulb temperature * WBT: Wet bulb temperature TABLE OF CONTENTSTABLE OF CONTENTS NOTE :NOTE : SAFETY PRECAUTIONS 2 REGULATORY INFORMATION 3 PRODUCT OVERVIEW & OPERATIONS 4~5 CARE & CLEANING 6 TROUBLESHOOTING 7 QUICK GUIDE BACK COVER The illustrations in this manual are for explanation purposes only and may differ from the actual unit. It is subjected to change without notice for future improvement. Information for Users on Collection and Disposal of Old Equipment and used Batteries [Information on Disposal in other Countries outside the European Union] These symbols are only valid in the European Union. If you wish to discard these items, please contact your local authorities or dealer and ask for the correct method of disposal. Note for the battery symbol (bottom two symbol examples): This symbol might be used in combination with a chemical symbol. In this case it complies with the requirement set by the Directive for the chemical involved. • Do not switch ON the unit when waxing the floor. After waxing, aerate the room properly before operating the unit. • Do not install the unit in oily and smoky areas. Pb 4 1 2 3 TIMER TEMP SET CHECK CLOCK RESET RC AC MODE OFF ON/ POWERFUL QUIET MODE FAN SPEED SET ON CANCEL OFF AIR SWING PPRROODDUUCCTT OOVVEERRVVIIEEW && OOPPEERRAATTIIOONNSS Front panel Receiver Auto OFF/ON button • Used when remote control is misplaced or malfunction. Action Mode Press once. Auto Press and hold until 1 beep is heard, then release. Cooling Press and hold until 1 beep is heard, then release. Press again until 2 beeps, then release. Heating Press the button to turn off. Airfl ow direction louver • Do not adjust by hand. e-ion AIR PURIFYING SYSTEM Do not touch during operation e-ion fi lters Active e-ion Power Module Active e-ion Generator Maximum distances: 8m Remote control display INDICATOR TO TURN ON OR OFF THE UNIT • Please be aware of the OFF indication on the remote control display to prevent the unit from starting / stopping improperly. TO SET TEMPERATURE • Selection range: 16°C ~ 30°C. • Operating the unit within the recommended temperature could induce energy saving. HEAT mode : 20°C ~ 24°C. COOL mode : 26°C ~ 28°C. DRY mode : 1°C ~ 2°C lower than room temperature. TO SELECT OPERATION MODE AUTO mode - For your convenience • Unit selects operation mode every 30 minutes according to temperature setting, outdoor and room temperature. During operation mode selection the power indicator blinks. HEAT mode - To enjoy warm air • Unit takes a while to warm up. The power indicator blinks during this operation. COOL mode - To enjoy cool air DRY mode - To dehumidify the environment • Unit operates at low fan speed to give a gentle cooling operation. (Green) (Orange) (Orange) (Orange) (Blue) (Blue) TO SET THE TIMER TO SET THE TIMER • , , and can be activated in all modes and can be cancelled by pressing therespective button again. • and or and can not be activated at the same time. • and can be activated even when the unit is turned off. In this condition, once e-ion indicator is ON, the unit will operate with AUTO fan speed andair swing. TO SELECT FAN SPEED (5 OPTIONS) • For AUTO, the indoor fan speed is automaticallyadjusted according to the operation mode. AIR SWING TO ADJUST AIRFLOW DIRECTION (5 OPTIONS) • Keeps the room ventilated. • If AUTO is set, the louvers swing left/right andup...

Descargar ahora

Introduzca dos números de la imagen: