Iniciar sesión:
Votos - 2, Puntuación media: 4 ( )

Manual de usuario Creda, modelo NPP50 75-773001

Fabricar: Creda
Tamaño del archivo: 496.76 kb
Nombre del archivo:
Idioma del manual:en
Enlace gratuito para este manual disponible en la parte inferior de la página



Resumen del manual


The Panel -How it works A heating element within the metal case warms its front face for direct radiation into the room and a gentle circulation of warm air around the room. The built-in thermostat with its adjustment knob located behind the controls door, controls the room temperature by sensing this from the air passing upwards through the panel. The knob selection provides settings from 1 to 6 and each increase in number equates to approximately 7°C temperature difference. Position 1 represents 7°C and would be used for frost protection when the property is not occupied. Position 3 represents 21°C and is the normal comfort position. NOTE – Should your heater fail to come on when the thermostat knob is at a low setting, this may be due to the temperature of the room being higher than the thermostat setting. Timer/Programmer A digital timer/programmer is built into the product and is situated behind the controls door. This will control the operation of the heater for the time periods set at the thermostat setting. Setting up If, at any time during setting, a period of approximately 7 seconds passes with no button pressed then the timer reverts to the clock display and saves the settings thus far. To set the clock, firstly press the left button below where it says “SETUP” on the display. Five options will be displayed on the right side of the display. These are PROG, DOWN, CLOCK, SUMMER and RANDOM. PROG will be flashing at this time. Press the “+” button twice to move the flashing to “CLOCK”, and then press the left button to “AFFIRM” the choice. The hour display will now be flashing and pressing the + or – buttons will set the display to the required setting. Then press the AFFIRM button and the minutes display will be flashing and again the + and – buttons will set the display to the required setting. Press the AFFIRM button and the day display will be flashing and the + and – button will set the day to the required setting. Press the AFFIRM button to end the clock setting and return to the clock display. To set the Program, firstly press the left button below where it says “SETUP” on the display. Five options will be displayed on the right side of the display. These are PROG, DOWN, CLOCK, SUMMER and RANDOM. PROG will be flashing at this time. Press the AFFIRM button and the 01ON display will be flashing. Press the AFFIRM button and the hour display will flash and be adjustable by the + and – buttons. Pressing AFFIRM will move the display to the minutes, and then to the days. The days have special groupings that can be selected by pressing the + and - buttons. They are MO TU WE TH FR, SA SU, MO TU WE TH FR SA, MO WE FR , TU TH SA, MOTU WE , TH FR SA, ALL DAYS and individual days. Make your selection and press AFFIRM. The 01ON display will flash. Pressing the + button will advance the display to 01OFF and the same procedure should be followed for setting the OFF time remembering to use the same day selection. The procedure should be followed thr...

Otros modelos de este manual:
Los acondicionadores de aire - NPP100 75-773002 (496.76 kb)
Los acondicionadores de aire - NP100 75-772902 (496.76 kb)
Los acondicionadores de aire - NPP100S 75-773012 (496.76 kb)
Los acondicionadores de aire - NPP150 75-773003 (496.76 kb)

Comentarios



Tu reseña
Tu nombre:
Introduzca dos números de la imagen:
capcha





Categoría