Votos - 2, Puntuación media: 5
(
)
)
|
Resumen del manual
ALWAYS STORE THE UNIT UPRIGHT IN ORDER TO MAINTAIN THE COMPRESSOR IN A PROPER CONDITION. 5. BE SURE TO UNPLUG THE UNIT BEFORE CLEANING. 6. THE HEATER MUST NOT BE LOCATED IMMEDIATELY BELOW A SOCKET OUTLET. 7. IF THE APPLIANCE IS COVERED, THERE IS A RISK OF OVERHEAT. 8. IF THE SUPPLY TOOL OF THIS APPLIANCE IS DAMAGED, IT MUST BE REPLACED BY A REPAIR SHOP APPOINTED BY THE MANUFACTURER, BECAUSE SPECIAL PURPOSE TOOLS ARE REQUIRED. NOTE: The air-conditioner can be connected only to a supply with system impedance no more than 0.4582 ohm. In case necessary, please consult your supply authority for system impedance information. NAMES OF PARTS OPRATION PANEL AIR OUTLET REMOTE CONTROLLER CASTER REAR COVER FRONT COVER AIR INLET OUTDOOR WATER PUMP DRAIN HOSE POWER CORD AIR INLET INDOOR AIR OUTLET OUTDOOR AIR INLET OUTDOOR CONTINUOUS DRAIN HOSE FRONT VIEW SIDE VIEW REAR VIEW Fig.1 ACCESSORIES PARTS : PARTS NAME : QUANTITY : DUCT 1 ADAPTOR A (FOR PERMANENT DUCT MOUNTING) 1 ADAPTOR B (FOR TEMPORARY DUCT MOUNTING) 1 WALL PLUG 4 SCREWS 4 ALKALINE BATTERIES 2 REMOTE CONTROLLER 1 WATER PUMP DRAIN HOSE 1 Fig.2 Check all the accessories are included in the package and please refer to the installation instructions for their usage. 2 OPERATION PANEL OF THE AIR CONDITIONER(COOLING AND HEATING) COOL/DRY/FAN/HEAT INDICATIOR DIGITAL DISPLAY FAN SPEED INDICATOR Green lamp will light when the mode is selected TEMP SETTING BUTTON Press your desired room temperature setting by pressing the button (up) or button (down) TIMER ON/OFF INDICATOR TIMER ON/OFF BUTTON Program the on/off timer function WATER FULL INDICATOR Red lamp will blink when the tank is full POWER INDICATOR POWER BUTTON Turn on/off the unit MODES BUTTON Select the operation mode from COOL.DRY.FAN.HEAT FAN SPEED BUTTON Select the fan speed from HIGH.MED or LOW INFRARED SIGNAL RECEIVER OPERATING PANEL Fig.3 OPERATION PANEL OF THE AIR CONDITIONER(COOLING ONLY TYPE) COOL/DRY/FAN INDICATOR DIGITAL DISPLAY FAN SPEED INDICATOR Green lamp will light when the mode is selected TEMP SETTING BUTTON Select your desired room temperature setting by pressing the button (up) or button (down) INFRARED SIGNAL RECEIVER TIMER ON/OFF INDICATOR TIMER ON/OFFBUTTON Program the on/off timer function WATER FULL INDICATOR Red lamp will blink when the tank is full POWER INDICATOR POWER BUTTON Turn on/off the unit MODES BUTTON Select the operation mode from COOL.DRY.FAN. FAN SPEED BUTTON Press the button to select the fan speed from HIGH.MED or LOW OPERATING PANEL Fig.4 3 OPERATING INSTRUCTING FOR THE AIR CONDITIONER Before Starting This Unit 1) Select a suitable location, make sure you have easy access to an electrical outlet. 2) Install the Flexible Exhaust Hose and the Adjustable Window Slider Kit as depicted in Fig.5 & Fig.5a Fig.5a Fig.5 NOTE: Step 2 is required only while using the cooling mode 3) Plug the unit into a 115V~60Hz grounded electrical outlet. 4) Make sure the water pump drain hose is correctly installed. .. 5) Press the on /...
Otros modelos de este manual:Los acondicionadores de aire - DOC-091R (1.56 mb)
Los acondicionadores de aire - DOC-091RH (1.56 mb)
Los acondicionadores de aire - DOC-091RH (1.56 mb)
Los acondicionadores de aire - DOC-091R (1.56 mb)