Votos - 2, Puntuación media: 5
(
)
)
|
Resumen del manual
This laminator is designed to provide quality Lamination of all thicknesses of plastic. The Model PL4A wil] easily laminate items up to ¥/*' wide such as ID cards, badges, membership cards, photographs, and luggage tags. The PL12A is designed for cards as well as larger items up to 12” wide, A thermostat allows you to adjust the temperature for laminating various materials. OPERATION Before using your laminator» be sure to observe the following precautions: * To prevent electric shock, do not operate the unit near a sink or other water sourceH * Do not immerse the laminator, its cord, or plug in water. * Do not use the laminator if the power cord is damaged, * Do not allow the cord to touch hot surfaces or hang over the edge of a cabinet or shelf * In case of a malfunction, return the unit to your dealer for service. The laminator does not contain any customer serviceable parts. To use your pouch laminator follow these steps: 1, Place the unit on a table and plug the power cord into a grounded 120VAC outlet, 2, Press the HEAT switch to the ON position (the switch will illuminate). The green indicator light will come on when the laminator is up to temperature and ready to laminate. 3, Press the RUN switch to the ON position (the switch will illuminate). 4, Insert the item to be laminated into a laminating pouch. Next, place the pouch into the paper laminating carrier, 5, Slowly feed the carrier, folded end firs[h into the laminator until it is picked up by the rollers. 6, Remove the carrier from the rear of the laminator after it has slopped moving. Leave the pouch inside the carrier for several seconds to cool before removing it, 7, Turn the RUN and HEAT switches OFF at the end of the day. clbcoffice 800-658-8788 1 TEMPERATURE ADJUSTMENT Your pouch laminator temperature has been factory set to provide high quality lamination under normal conditions, [f you use a heavier paper or use & different laminating film, the temperature may be adjusted by turning Hie temperature control knob on the bottom of the unit To increase the temperature: 1. Turn the temperature control knob clockwise one division. Wait until the indicator light comes on before laminating, 2. Repeat step 1 until the laminator produces the desired results. To decrease the temperature: 1. Turn the temperature control knob counter-clockwise to reduce the temperature. Tlie green indicator light will remain on. Wait several minutes before laminating. 2, Repeat step I until the laminator produces the desired re suits. If the pouch does not seal or the lamination is cloudy, the temperature is too low. If the lamination contains bubbles or wrinkles the temperature is too high. abcoffice 800-658-8788 2 Specifications Dimensions: PL4A PLI2A 3" Jt ICT x VA” (20,3 x 25A x 9,5cm) S'/^x W”:i4i*''{2I.6x4S,3x iG,5cm) Weight: PL4A PL12A 7V* tbs, (3.97 Kg) ISVi' lbs.{7.04 ¿g) Power: mVAC, 5G/Ó0HZ PL4A PLI2A 240 watts 720 ...
Otros modelos de este manual:Laminador - PL4A (971.41 kb)