Votos - 3, Puntuación media: 4.3
(
)
)
|
Resumen del manual
Sabre Power Pack Carton Contents IMPORTANT ! Please check the contents of the carton are correct BEFORE assembling your new product. IF ANY PARTS ARE MISSING CONTACT:- Husqvarna Outdoor Products Customer Service Department direct Telephone : 01325 300303, Fax : 01325 318193 Safety 1. Always charge the Power Pack indoors and store in a cool dry place - out of the reach of children. 2. Use only the charger provided with your unit. Use of any other charger could permanently damage the Power Pack. 3. Use the charger with standard domestic household electrical outlets only. 4. Do not abuse the charger or charger cord. 5. Do not use the charger if the charger or charger cord is damaged. 6. Use the charger indoors only. 7. Do not use the charger outdoors. 8. Do not charge the Power Pack or use the unit in an explosive or corrosive environment. Avoid areas where flammable liquids or gases are present to avoid creating a fire or explosion. 9. Do not attempt to repair the unit including the Power Pack. 10.Do not incinerate or mutilate the Power Pack. Batteries contain hazardous chemicals. Dispose of properly. If not used properly this product can be dangerous! This product can cause serious injury to the operator and others, the warnings and safety instructions must be followed to ensure reasonable safety and efficiency in using this product. The operator is responsible for following the warning and safety instructions in this manual and on the product. Explanation of Symbols on your product Warning Read the user instructions carefully to make sure you understand all the controls and what they do. Power Pack Care 1. If over a period of time the Power Pack quickly runs down after a full 24 hour charging period, a replacement Power Pack is needed. 2. There will be some charge present in the Power Pack but to ensure maximum running time, recharge your Power Pack for 24 hours before use. 3. Permanent connection to the charger in a well ventilated area will automatically keep your Power Pack fully charged ready for use. 4. To prevent permanent Power Pack damage, never store in a discharged condition. 5. Contact your local approved service centre/dealer/distributor for a replacement Power Pack and for safe disposal of your old Power Pack. 6. Battery 24 Volt 4.5 Amp/Hour "High Power" Sealed for Life No maintenance required • IMPORTANT DISPOSE OF YOUR OLD POWER PACK SAFELY DO NOT CUT OPEN, BURN OR INCINERATE. Power Pack Replacement Your Power Pack is non-servicable. Should your Power Pack need to be replaced contact your local approved service centre or dealer who will replace your old Power Pack with a genuine Flymo replacement Power Pack. Winter Storage 1. Fully charge for 24 hours before winter storage. 2. If you are unable to leave your Power Pack on permanent charge, re-charge the Power Pack every 3 to 4 months for a full 24 hour charging period to top up the Power Pack charge during winter storage. 3. Avoid extended storage without re-charge. 4. Store in a cool dry place. For further information on Power Pack replacement contact Husqvarna Outdoor Products Customer Service direct:- Telephone : 01325 300303 Fax : 01325 318193 Power Pack Fitting the Battery Charger and Charging the Power Pack A 1 • Attach the Power Pack charger bracket to the wall using the four screws provided (A) • IMPORTANT ! Switch charger off at the socket before connecting or disconnecting the Power Pack to the charger bracket Initial Charging Procedure • The Power Pack should be charged for 24 hours before use. • Re-charge your Power Pack immediately after every use for the full 24 hour charging period. • The Power Pack can be left connected to the charger permanently, with the charger switched on, without fear of overcharging. • The charger will automatically keep the Power Pack topped up with charge during storage and will ensure that the Power Pack is ready for use. 1. Use the charger indoors only. 2. Ensure the charger is not exposed to moisture. Keep the charger and Power Pack dry at all times. Keep the charger well ventilated during charging. 3. Ensure the Power Pack is correctly located into the bracket (B) and the charge connector (A1). 4. Plug the charger into a suitable household electrical socket and switch on.(B1) 5. The indicator lamp glows continuously during charging. 6. Full charge will be achieved in 24 hours. During charging the charger becomes warm. This is normal and means the charger is operating correctly. Re-Charging Your Power Pack 1. Re-charge the Power Pack as soon as the cutting power of your product begins to die and slow down. 2. Avoid running the cordless product into "deep" discharge, i.e. avoid flattening the Power Pack completely. 3. Follow the procedure outlined in the Initial Charging Procedure. 4. Charging the Power Pack according to these instructions should ensure maximum battery life. B Environmental Information Husqvarna Outdoor Products are manufactured under an Environmental Management System (ISO 14001) us...