Votos - 2, Puntuación media: 4
(
)
)
|
Resumen del manual
In Canada, this warranty is offered by Sunbeam Corporation (Canada) Limited doing business as Jarden Consumer Solutions, located at 20B Hereford Street, Brampton, Ontario L6Y 0M1. If you have any other problem or claim in connection with this product, please write our Consumer Service Department. PLEASE DO NOT RETURN THIS PRODUCT TO ANY OF THESE ADDRESSES OR TO THE PLACE OF PURCHASE. 9100040003006 HAP70607EM1 Printed In China Owner’s Guide HAP706 True HEPA Allergen Remover PLEASE READ AND SAVE THESE IMPORTANT INSTRUCTIONS OPERATING INSTRUCTIONS IMPORTANT: • Remove all plastic bags from filters before use. • DO NOT POINT FILTERED AIR OUTLET TOWARDS WALL. To operate your air cleaner: 1. Plug into a 120V AC electrical outlet. 2. Select the operating speed of HIGH ( ), MEDIUM ( ) or LOW ( ) by turning the speed control knob to the appropriate setting. 3. To release negative ions into the filtered air, turn the Ionizer ( ) Control Knob to ON and the light will illuminate. 4. The lonizer will not work unless air cleaner is running. 5. For optimum air filtration, it is recommended to operate the air cleaner continuously. Its rugged motor has been designed to give many years of use. REPLACING THE FILTER IMPORTANT: • NOTE: DO NOT attempt to wash and re-use the HEPA filter. • If the filters are enclosed in plastic bags, remove before use. NOTE: Every few weeks, check the condition of filters. Filter life will vary, depending on air quality and usage. On average, HEPA filters need replacement every 10-12 months. To replace your filter: 1. Turn off and unplug the air cleaner. 2. Open the air inlet grill and examine the foam prefilter. Remove any dust or lint, and wash in warm soapy water. Rinse, drip dry, and place back into grill inlet. 3. Remove HEPA filter from the unit by pulling it gently towards you and discard it. DO NOT attempt to clean the old HEPA filter. 4. Install the new HAPF300 HEPA filter into the unit.This model utilizes a hang tab and filter clips to insure that the filter is properly in place. Before replacing the filter, make sure that the hang tab is securely in place. The clip can only be attached to the tabs on the filter one way. The filter clip should easily slide onto the filter hang tab with only a small amount of pressure. DO NOT use force while attaching the clip to the filter. (Fig. 2) 5. Align the clip on the top of true HEPA filter with rails on the inside of the cleaner unit. Gently slide the filter onto the rail. (Fig. 3) 6. Replace air inlet grill. IMPORTANT SAFEGUARDS F E ATURES OPERATIONS, CLEANING/MAINTENANCE SAFETY INSTRUCTIONS When using electrical appliances, basic safety precautions should always be followed to reduce the risk of fire, electric shock, and injury to persons. These precautions include: 1. Read all instructions before using the appliance. 2. To avoid fire or shock hazard, plug the appliance directly into a 120V AC electrical outlet. 3. If the filter is covered by a bag when shipped, remove plastic bag be...
Otros modelos de este manual:Jig Saw y - HAP706 (720.35 kb)
Jig Saw y - HAP706 (720.35 kb)
Jig Saw y - HAP706 (720.35 kb)
Jig Saw y - HAP706 (720.35 kb)