Votos - 3, Puntuación media: 4.7
(
)
)
|
Resumen del manual
Be 3® Quasar 12-Volt 2-Mile Navigational Light Without Wire Leads: 3100-3104, 3130-3134 With 7" Wire Leads: 3120-3124, 3150-3154 Attwood marine hardware, navigational lighting, bilge pumps, and other marine accessories are specified more than any other brand by America’s best-known boat manufacturers as original equipment. Look to Attwood for quality replacement parts and marine accessories. SAVE THESE INSTRUCTIONS Form Number 69385 Rev. B 03-10 Meets USCG CFR 183.810, ABYC A-16 requirements, and all applicable standards as tested by Imanna Labs, 7/8/1995. 2 Nautical Mile visibility. Uses 9230-7 Lamp, 13V, 8 Watt. FEATURES The new Attwood 12-volt DC Quasar two-mile navigational sidelights are designed for mounting on horizontal surfaces, such as the gunwale or deck. They meet the ABYC Standard A-16, COLREG 72, and other selected international standards. REQUIRED FOR INSTALLATION The stylish housing is supplied in UV-stable, color-matched polycarbonate or chromed HIPP (High Impact Electroplated Plastic). The lens completely encapsulates the bulb and socket assembly for splash resistance. When used with the optional base gasket, these lights are virtually waterproof. • Screwdriver. • Drill with suitable bits — 1-..." (29mm). • Base gasket (Attwood # 910467) or marine sealant. • Three #8 or #10 stainless steel pan head screws. LOCATION 1. Position light(s) on a horizontal surface (± 5°) of the gunwale or deck. If installing a combination light, place it on the furthermost tip of the bow on the centerline of the boat. (See Figure 1a.) If installing sidelights, the red lens must be on the port (left) and the green on the starboard (right) as you stand onboard facing the bow of the boat. (See Figure 1b.) Figure 1a Figure 1b 112.5° Arc Must Be Clear Green (Starboard) Red (Port) Red (Port) Green (Starboard) 2. Ensure that there are no front or side obstructions, such as rail stanchions, chocks, anchors, etc., within the arc of visibility (112.5° each side). certain that centerline of hole is aligned with boat centerline. Drill a 1-..." (29mm)-dia. hole. (See Figure 2.) Figure 2 (Applies to Quasar Light, not Snap Base) 13/16" (21mm) • 15/16" (24mm) • • FORWARD (14mm) (25mm) 2-1/4" (57mm) 1-1/8" (29mm) •• 9/16" • • 1" • • • MOUNTING INSTRUCTIONS 1. To access mounting holes inside the base: Loosen retaining screw one full turn; lift rear of cover, use flat base screwdriver if necessary to raise rear, rotate cover up and forward to unlock; twist lens counterclockwise and remove. 2. Place base into hole and align front and back with the boat centerline. Use base to mark pilot holes for the mounting screws. Drill pilot holes. 3. Feed the power source terminals up through the deck and attach to base terminals. Insulated terminals are recommended. CAUTION Position carefully on aluminum boats so that wires do not contact the hull. 4. Apply gasket (Attwood # 910467) or sealant to deck mounting area. Gasket is highly recommended on aluminum surfaces. Place base ove...
Otros modelos de este manual:equipamiento barco - 3100 (478.55 kb)
equipamiento barco - 3104 (478.55 kb)
equipamiento barco - 3124 (478.55 kb)
equipamiento barco - 3130 (478.55 kb)