Votos - 3, Puntuación media: 4.3 ( )

Fabricar: Attwood Tamaño del archivo: 369.93 kb Nombre del archivo: Idioma del manual:

Lights must be parallel to centerline of the boat (See Figure 1b). Figure 1a Figure 1b Green (Starboard) Red (Port) Red (Port) Green (Starboard) 3. Make sure there are no obstructions at the front or side such as rail stanchions, chocks, anchors, cleats, etc. within the light’s arc of visibility (112.5 degrees each side). bicolor light, location must be on the boat centerline. If installing a sidelight pair, both must be the same distance from the bow. At the marked location(s), make a mark for a ..." hole. This hole is necessary for wire passage and lamp ventilation (See Figure 2). Figure 2 • • • • • • • Cover Screw • Lens Cover Lens #10 Stainless Steel Mounting Screws O-Ring Base • Gasket Butt-Joint Connectors 3/4" Hole Aligned with Boat Centerline MOUNTING INSTRUCTIONS 1. Remove the cover and lens by removing the Phillips head screw in the cover and lifting off (See Figure 2). 2. Align hole beneath light base with the position you’ve marked for the clearance hole. Set lens toward the bow and align arrow on base with the boat centerline. Use the light base as a template to mark locations for the mounting screw pilot holes (use at least 2 #10 stainless steel screws). CAUTION: Position holes carefully on aluminum boats so that wires do not contact the hull. 3. Drill clearance hole and pilot holes for the mounting screws. WIRING INSTRUCTIONS The power supply must be 12-volt DC ONLY. Use crimp type marine-grade connectors with suitable insulation. Protect all connections with suitable materials. NOTE: Failure to make proper connections and fuse the light properly (see back page) will void the product warranty. 1. Connect one lead to the negative (-) post of the 12-volt supply. Connect the other lead to a fused and switched positive (+) 12-volt supply. Sidelights require 1-amp fusing per lamp: a 1-amp fuse for the Bicolor Combination light, a 2-amp fuse for the Sidelight Pair. Note that navigation rules require sidelights to be operated separately from anchor lights. Use either two switches or a single switch with three positions for off/anchor/running (See Figure 3). Figure 3 2-Amp Fuse Switch 2. Check gasket to be sure the hole lip is down. Feed wires and connectors down through the gasket (See Figure 4). 3. Be sure base is seated into the gasket ring all the way around (See Figure 4 Detail). 4. Align base so the hole lip fits down into the wire clearance hole. Insert two #10 stainless steel mounting screws and fasten them to the deck. Note: Do not fasten screws so tightly that the gasket is deformed. 5. To replace lens: Be sure O-ring is seated on the base screw mount. Seat lens so the base tabs fit in the lens grooves and base screw mount lines up with the lens screw hole. Be sure the gasket is outsidethe lens at the back. Figure 4 Detail Lens Lens Groove Base Tab O-Ring Base Gasket Hole Lip Lens Gasket 6. Place stainless steel cover over lens. Be sure gasket is inside the stainless steel cover at the back. Reinstall screw into cover (See Figure...

Descargar ahora

Introduzca dos números de la imagen: