Iniciar sesión:
Votos - 2, Puntuación media: 5 ( )

Manual de usuario Lenoxx Electronics, modelo 822

Fabricar: Lenoxx Electronics
Tamaño del archivo: 264.98 kb
Nombre del archivo: 660e8d66-1d26-49a6-bee1-6e506645b591.pdf
Idioma del manual:en
Enlace gratuito para este manual disponible en la parte inferior de la página



Resumen del manual


PLAY ( ) BUTTON 3. FAST F. ( ) BUTTON 4. HEADPHONES ( ) JACK 5. VOLUME CONTROL 6. BASS BOOST SWITCH 7. BATTERY DOOR (at back) 8. BELT CLIP (at back) 6 ---1 ---IB-822(CL)-WM-E-070506 7 IB-822(CL)-WM-E-070506.pmd 1 7/6/2006, 11:57 AM FCC NOTES This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesirable operation. WARNING: Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: -Reorient or relocate the receiving antenna. -Increase the separation between the equipment and receiver. -Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. -Consult the dealer or an experienced radio / TV technician for help. ---2 ---IB-822(CL)-WM-E-070506 IB-822(CL)-WM-E-070506.pmd 2 7/6/2006, 11:57 AM READ THIS IMPORTANT INFORMATION BEFORE USING YOUR HEADPHONES This personal cassette player is one of the most exciting and innovative consumer electronics products ever developed. With it you can now enjoy listening to your favorite music wherever you go, through the supplied headphones. But, for YOUR comfort, health and safety be sure to observe the following guidelines. HEARING COMFORT & WELL-BEING • Do not play your headphones at a high volume. Hearing experts advise against continuous extended play. • If you experience a ringing in your ears, reduce volume or discontinue use. TRAFFIC SAFETY • Do not use while operating a motorized vehicle. It may create a traffic hazard and is illegal in many areas. • You should use extreme caution or temporarily discontinue use in potentially hazardous situations. • Even if your headphones are an open-air type designed to let you hear outside sounds, do not adjust the volume too high so that you can hear what is around you. ---3 ---IB-822(CL)-WM-E-070506 IB-822(CL)-WM-E-070506.pmd 3 7/6/2006, 11:57 AM BATTERY INSTALLATION Slide the BATTERY DOOR in the direction shown by the arrow to open the door and insert 2 “AA” batteries, taking care not to reverse the positive and negative polarities. Alkaline batteries are recommended and will normally provide more playing time. • Do not mix old and new batteries. • Do not mix alkaline, standard (carbon-zinc) or rechargeable (nickel-cadmium) batteries. NOTE: • Remove the batteries during long periods (about 30 days or more) of nonuse, possible battery leakage and corrosion can damage the set. • If the sound becomes weak and unclear, the batteries may be weak. Replace both batteries at once. TO INSERT THE TAPE 1. Open the CASSETTE DOOR by holding the door as shown and gently pulling it to you. 2. Insert the tape into the cassette holder ON THE DOOR. 3. Close the CASSETTE DOOR gently till it clicks shut. CAUTION: Do not pull door too strongly or you may damage the door, treat this set with care and it will last a long time. ---4 ---IB-822(CL)-WM-E-070506 IB-822(CL)-WM-E-070506.pmd 4 7/6/2006, 11:57 AM TAPE PLAY 1. Check whether or not the tape is tight before it is inserted. • To keep the tape from tangling, firmly wind the tape before inserting it into the player. • Use of a cassette with more than 90 minutes, such as C-120 (120 minutes), is not recommended. The extreme thinness of this tape may damage this set. 2. Open the CASSETTE DOOR by hand, face the side to be played toward you, and insert the cassette tape. Close the CASSETTE DOOR. 3. Connect the headphones to the jack and adjust the headphones band for proper fit. 4. Press the PLAY button. 5. Adjust the VOLUME to control the sound level you like. 6. To skip portions of the cassette tape, press the FAST F. button. 7. To stop playing the cassette tape, press the STOP button, and the power source is also turned off. (This set has a built-in auto-stop and the tape mechanism will stop playing and shut off when it reaches the end of the tape.) 8. To hear the other side of tape, flip it over and press PLAY . TO HEAR THE SAME SONG AGAIN 1. Remove the tape, flip it around to...


Comentarios



Tu reseña
Tu nombre:
Introduzca dos números de la imagen:
capcha





Categoría