Votos - 3, Puntuación media: 4.7 ( )

Fabricar: Kenwood Tamaño del archivo: 798.03 kb Nombre del archivo: Idioma del manual:

Otros manuales para este modelo:

Unidad - KRC-194G (830.3 kb)

. No ACC position on vehicle ignition. . Connect the same cable to the ignition as the battery ? If you have selected Standby mode, the power will automatically. . The Power OFF Timer function has been activated. . If you do not want the power to go OFF automatically, cancel the Power OFF Timer function. ? Nothing happens when the buttons are pressed. . The computer chip in the unit is not functioning normally. . Press the reset button on the unit (page 4). ? There’s a source you can’t switch. . There’s no tape inserted. . Set the media you want to listen to. If there’s no media in this unit, you can't switch to each source. ? There’s a source you can’t switch. . The Disc changer isn’t connected. . Connect the Disc changer. If the Disc changer isn’t connected to it's input terminal, You can't switch to an external disc source. ? The faceplate does not open or close. . The faceplate is incorrectly attached. . Reattach the faceplate correctly, See the section on (page 8). ? The memory is erased when the ignition is turned OFF. . The battery wire has not been connected to the proper terminal. . Connect the wire correctly, referring to the section on . . The ignition and battery . Connect the wire correctly, referring to the section . ? The TEL mute function turns ON even not connected. . The TEL mute wire is touching a metal part . Pull the TEL mute wire away from the metal part ? Even if Loudness is turned ON, high-pitched tone for. . Tuner source is selected. . High-pitched tone isn't compensated for when in Tuner source. ? No sound can be heard, or the volume is low. . The fader or balance settings are set all the way to one side. . Center the fader and balance settings. . The input/output wires or wiring harness are connected incorrectly. . Reconnect the input/output wires or the wiring harness correctly. See the section on "Connecting Wires to Terminals". . The cassette tape is bad. . Try playing another cassette tape. If works fine, the first tape was bad. ? The sound quality is poor or distorted. . One of the speaker wires is being pinched by a screw in the car. . Check the speaker wiring. . The tape head is dirty. . Clean the tape head. . The speakers are not wired correctly. . Reconnect the speaker wires so that each output terminal is connected to a different speaker. ? The Touch Sensor Tone doesn’t sound. . The preout jack is being used. . The Touch Sensor Tone can’t be output from the preout jack. — 25 — English English ? Even though Synchronize be adjusted. . The received RDS station sending time data. . Receive another RDS station. Tuner source ? Radio reception is poor. . The car antenna is not extended. . Pull the antenna out all the way. . The antenna control wire is not connected. . Connect the wire corre...

Descargar ahora

Introduzca dos números de la imagen: