2 Control Functions ......................................................................pg. 4 Discrimination Points ................................................................pg. 5 Searching ..................................................................................pg. 7 Pinpointing ................................................................................pg. 9 Zero Motion Pinpoint Mode ..................................................pg. 9 Pinpointing in the Motion Search M

Subject to improvement or modification without notice. WEIGHT Fisher Research Laboratory does not warrnt suitability to specific use. Fisher Research Laboratory shall in no event be liable for any direct, incidental, consequential or indirect damages. 3.5 lbs. LENGTH Extended ....................................................................52” 2 Collapsed.....................................................................42” 2 FREQUENCY VLF-Search.............................................

. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .3-4 Batteries . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .5 Quick-Start Demo . . . . . . . . . . . . . . . . . . . . . . . . . .6-7 Basic Operation . . . . . . . . . . . . . . . . . . . . . . . . . . .8-11 All Metal . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .9 Discrimination . . . . . . . . . . . . . . . . . . . . . . . . . .10 Notch . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

Always begin use at a reduced sensitivity level; this device is designed to work “into-the-noise”, so expect chatter at high sensitivity. 2) Do not use indoors. This detector is for outdoor use only. Many household appliances emit electromagnetic energy, which can interfere with the detector. If conducting an indoor demonstration, turn the sensitivity down and keep the search coil away from appliances such as computers, televisions and microwave ovens. If your detector beeps erratically, turn of

Figure 4 6. Plug in the search coil’s plug into the search coil jack on the Tool’s control panel. Make sure that the pins on the plug align with the holes in the jack (see Figure 4). Note: The search coil’s plug fits into the connector only one way. Never force the plug; the plug could become damaged. To disconnect the plug, never pull on the cable; always take hold of the plug and pull it out of the connector. Loosen the knob at the search coil’s 7. end, then adjust the search coil’s end, then

Extended 3. high volume listening can lead to permanent hearing loss. Do not wear headphones while 4. operating your detector near high- traffic areas. Be safe and pay attention to traffic. Functions and Indicators VOLUME - Sets the sound level. TUNE - Sets the sensitivity level of the unit. NOTE: Set to the lowest setting when away from any metal objects. MODE - Sets the unit to two modes: OPERATE and BATT TEST. Red Tuning Button - Press this button and set the TUNE dial to 0 to properly balanc

Always begin use at a reduced sensitivity level. Expect chatter or internal noise at high sensitivity. 2) Do not use indoors. This detector is for outdoor use only. Many household appliances emit electromagnetic energy, which can interfere with the detector. If conducting an indoor demonstration, turn the sensitivity down and keep the search coil away from appliances such as computers, televisions and microwave ovens. If your detector beeps erratically, turn off appliances and lights. Also keep

10 Pinpointing a Target ........................................................................................................ 10 Troubleshooting ................................................................................................................... 11 Care ....................................................................................................................................... 11 © 2000 RadioShack Corporation. All Rights Reserved. RadioShack and RadioShack.com a

Always begin use at a reduced sensitivity level; increase sensitivity only after you have become familiar with the detector. 2) Do not use indoors. This detector is for outdoor use only. Many household appliances emit electromagnetic energy, which can interfere with the detector. If conducting an indoor demonstration, turn the sensitivity down and keep the search coil away from appliances such as computers, televisions and microwave ovens. If your detector beeps erratically, turn off appliances

Obey all safety messages that follow this symbol to avoid possible injury or death. DANGER indicates a hazardous situation which, if not avoided, will result in death or serious injury. WARNING indicates a hazardous situation which, if not avoided, could result in death or serious injury. CAUTION, used with the safety alert symbol, indicates a hazardous situation which, if not avoided, could result in minor or moderate injury. NOTICE is used to address practices not related to personal injury. C