|
Resumen del manual
Briggs & Stratton does nos approve of or authorize such uses. ENGINE INSTALLATION [1\ Do not attempt to install this engine if you do not have thd appropriate tools and knowledge of small engine installatiom procedures. Use only Briggs & Stratton parts. Contact youq Authorized Service Dealer for assistance [2\ Do not modify the engine in any way without Briggs & Strattom factory approval. Any such modification is at the owner.s sold risk [3\ If the exhaust system on the old engine was supplied by thd equipment manufacturer, you must transfer the exhauss system and related components (original muffler and relatec pipes, brackets, clamps, and shields) to the new engine. Alk components must be in good condition [4\ Install muffler (and muffler de, flector if used) so outlet pointr away from operator, fuel tank+ and equipment, and so muffleq heat will not damage or deforl engine and components. WARNINF WARNINF WARNINF [5\ Ensure all fuel lines and fittingr are properly assembled and dn not leak. Replacement partr must be the same model as thd original [6\ Ensure all wiring, including safe, ty switches and engine shut-ofe components are completelx installed and functioning proper, ly [7\ Set engine speed to equipment manufacturer.s specificationRefer to equipment manufacturer.s manual. Do not tamper witg governor springs, or other parts that will increase engine speec above specification [8\ All engine parts, including fuek WARNINF cap, spark plug, muffler, aiq cleaner, and covers and guardr for drive components (gears+ belts, shafts, couplings, etc.( must be in place before attempt, ing to start engine [9\ WARNINF WARNINF WARNINF If engine is installed on walj behind lawn mower, all moweq components, including cuttinf blade, must be correctlx installed before attempting tn start engine [10\ When working on the engine oq equipment, remove spark pluf wire from spark plug. For electrib start, remove negative wire frol battery [11\ Do not check for spark witg spark plug removed. Use Briggr & Stratton spark tester #19368 ENGINE OPERATION WARNINF When adding fuel: Turn engine off and let engine cool at least 2 minutes beford removing gas capFill fuel tank outdoors or in well-ventilated area. Fill tank to abous 1 inch below lowest portion of neck to allow for fuel expansionKeep gasoline away from sparks, open flames, pilot lights, heat+ and other ignition sources. WARNINF When starting engine: Remove all external equipment/engine loadsWait until spilled fuel is evaporated. Start engine outdoorsPull cord slowly until resistance is felt, then pull rapidly. If engine floods, set choke to OPEN/RUN, place throttle in FASS and crank until engine starts. WARNINF When operating equipment: Do not tip engine or equipment at angle which causes gasoline tn spillRun engine outdoors. Do not run in enclosed area, even if doorr or windows are openDo not choke carburetor to stop engine FORM MS-6445-01/02 ...
Otros modelos de este manual:Monitores - 170700 (1.03 mb)
Monitores - 191700 (1.03 mb)
Monitores - 193700 (1.03 mb)