Votos - 2, Puntuación media: 4.5
(
)
)
|
Resumen del manual
We recommend the use of a pair of gloves when cleaning the cold panels as you might injure your fingers and hands and/or damage the appliance beyond repair. BEKO plc declines to accept any liability should the instructions not be followed. 4 IMPORTANT INSTALLATION INSTRUCTIONS 1. To avoid a hazard due to instability of the appliance, it must be fixed in accordance with the instructions. 2. Do not operate this applliance unless installed to furniture. 3. The appliance should be located on a smooth surface. The four front and back feet can be adjusted as required. To ensure that, your appliance is standing upright adjust the four front and back feet by turning clockwise or anti-clockwise, until the product is in firm contact with the floor. Correct adjustment of feet avoids excessive vibration and noise. 4. Refer to "Cleaning and Care" section to prepare your appliance for use. 10 mm To avoid any loss in performance, air suction channels should not be obstructed. (140 cm2) Minimum distance between the wall and the appliance must be at least 10 mm. 40 mm 40 mm10 mm Wall Appliance 5 REPOSITIONING THE DOOR Follow the step by step instructions and the diagram below. Numbers in bracketsrefer to diagrams. 1 2 4 3 1 2 6 5 11 12 7 8 9 10 11 12 6 1. Switch off at the socket outlet and pull out the mains plug. 2. Remove all food, loose items and fittings from inside the appliance and door shelves. 3. Unscrew the bolts and remove the upper and bottom hinges from the cabinet and door. (1) (2) 4. Unscrew the bolts and remove the furniture fixing parts from the door. (3) (4) 5. Remove stoppers. (5) (6) 6. Reposition the furniture fixing parts on the opposite side. (7) (8) 7. Fit the stoppers on the opposite side. (9) (10) 8. Reposition the upper hinge on the opposite side as bottom hinge (12) 9. Reposition the bottom hinge on the opposite side as upper hinge. (11) Locate the door and tighten the bolts fixing the door. 7 STARTING Final Check Before you start using the freezer check that: 1. The feet have been adjusted and the product is level. 2. The interior is dry and air can circulate freely at the rear. 3. Clean the interior as recommended under "CLEANING AND CARE." 4. Insert the plug into the wall socket and switch on the electricity supply. Avoid accidental disconnection by taping over the switch. 5. You will hear a noise as the compressor starts up. The liquid and gases sealed within the refrigeration system may also give rise to noise, whether the compressor is running or not which is quite normal. 7. Front edges of the cabinet may feel warm. This is normal. These areas are designed to be warm to avoid condensation. 9. Do not load the appliance immediately it is switched on. Wait until the correct storage temperature has been reached. We recommend that you check the temperature with an accurate thermometer (see; Temperature Control and Adjustment). Important Notes : 1. If there is a power failure do not open the door. Frozen food should not be affected if the failure lasts for less than 19 hours. If the failure is longer, then the food should be checked and either eaten immediately or cooked and then re-frozen. 2. If you find the freezer door difficult to open just after you have closed it, don't worry. This is due to the pressure difference which will equalise and allow the door to open normally after a few minutes. 3. Always wrap food using a suitable packaging material before storing in your appliance to avoid contact with the appliance surface and food remains for hygiene reasons. 8 TEMPERATURE CONTROL AND ADJUSTMENT There are three coloured indicator lights located inside the appliance which show the operatingmode of the freezer. Green Indicator (1) Illuminates when the appliance is connected to the mains and will glow as long as there is electricity present. The green light will not glow if the thermostat is set in the 'O' position. The green indicator does not give any indication of the temperature inside the freezer. Amber Indicator (2) This indicator will glow when the fast-freeze switch (4) is on and will continue to glow until the fast-freeze switch is turned off. The compressor will run continuously whilst the fast-freeze switch is on. Fast-freeze operation is for freezing fresh food (see Freezing Fresh Food, section). Red Indicator (3) Illuminates: a. If the pre-set temperature can not be maintained. b. If the appliance is overloaded with fresh food. c. If the appliance door is left open accidentally. Thermostat knob (5) The thermostat knob is located on the indicator light frame. Important: When you press the fast-freeze switch, there may be a short delay before the compressorstarts to operate. This is normal and not a compressor fault. 4 5 3 1 2 STORING FROZEN FOOD Prepacked commercially frozen food should be stored in accordance with thefrozen food manufacturer's instructions for a frozen food storage compartment. The freezing area is marked with symbol on the door liner. To ensure that the high qual...